CAUTION!
SIGHT
STINK FILTER
Stink Blaster Blaster™ is an air gun that
should not be fired at close proximity to the
eyes and mouth.
PLUNGER HANDLE
Take care when firing Stink Blaster Blaster™
to stay clear of plunger handle.
STINK POD
TRIGGER
BELLOWS
STINK FILTER
RELEASE
STINK BLASTER BLASTER™
The life of your Stink Pods will greatly increase if you close them after each use and store them in the locking blister when
not in use. Do not leave Stink Pod door open when not in use.
INSERTING STINK PODS
1. Locate the stink pod you wish to use.
Insert stink pod
2. Twist the stink filter nozzle cap counter clockwise until it is stopped.
3. Lift the nozzle cap off.
4. Twist the stink pod open as shown and place in the nozzle.
5. Replace nozzle cap.
TO FIRE THE STINK BLASTER™ BLASTER
1. With the nozzle resting over
the barrel, pull the plunger
1
back until it locks into
extended position.
2
2. Squeeze the Nozzle
Releaser to free up the air
passage.
3
3. Aim, squeeze the trigger!
2
TIPS
To aim your Stink Blaster Blaster™ you can use the scope to aim at objects over
6 feet away. ꢀLine the front pointer up with your target while looking through the scope.
Many people tend to aim low because of the large size of the bellows. If you are not sure,
always aim higher than you would guess.
Spin Master Ltd.
450 Front Street West ,Toronto ,ON M5V 1B6 Canada
Phone: 1-800-622-8339 Fax: 416-364-8005
© 2004 Spin Master Ltd. TM Stink Blaster is a trademark of Spin Master Ltd.
All Rights Reserved.
Item #61263
REV 0
U.S. English
|