Salon Finish
Professional Hair Straightener
INSTRUCTION BOOKLET.
PLEASE READ THIS BOOK THOROUGHLY AND RETAIN FOR FUTURE REFERENCE.
HS9200
Features of your Professional Straightener.
Flexible
rubberised
cord
Handle
lock/release
On/off
switch
Power
on light
Cool tip
Hang
up loop
Power
connect
light
Extra large
flat plates
Removable
detangling combs
Salon design and performance
Locking handle
The Sunbeam Professional Straightener gives
you that sleek, salon finish at home.
Ensures smooth, even straightening and
convenient, compact storage.
Professional PTC element
Power and Heating Indicator Lights
Heats up to 210oC in less than 2 minutes and
maintains a constant temperature between
180oC and 190oC for fast, sleek straightening.
The red light illuminates to indicate that the
straightener is connected to the power outlet
and the power is turned on. The green light
illuminates when the unit is switched on (1) and
heating.
Extra large plates
The extra large flat plates allow you to
straighten larger sections of hair at any one
time, for faster, smoother results.
Removable detangling combs
Help to keep hair smooth and free of tangles
during straightening, or can be removed as
desired.
2
Using your Professional Straightener.
6. Hold the styler in position for 3 to 5 seconds,
Using Your Professional Straightener
1. Insert the plug into the power outlet and
turn the power on. The red light will
illuminate to indicate that the straightener is
connected to the power outlet and the
power is turned on. Switch the on/off switch
to on (1). The green light will illuminate to
indicate that the unit is switched on and
heating.
depending on the type of hair (3 seconds for
fine hair and up to 5 seconds for thicker or
curlier hair).
7. Once the hair is heated carefully slide the
styler along the section of separated hair,
making sure that the hair is heated and
straightened all the way to the ends.
8. Select another section of hair and repeat the
process. Continue until all of the hair has
been straightened.
2. Allow the straightener to heat for 2 minutes
before using.
3. Ensure hair is completely dry. Brush your hair
9. Once straightening is complete, switch the
unit off (0) and remove the plug from the
power outlet. Allow to cool completely
before storing.
thoroughly.
4. Separate out a section of hair approximately
4cm in width and smooth it with a comb.
5. For best results, start at the scalp and work to
the ends of the hair. Place the separated
section of hair between the flat plates and
close the handle gently around the hair.
Care and Cleaning.
After use, switch the on/off switch to the off
position (O), remove the plug from the power
outlet and allow the styler to cool before
storing.
Do not wrap the cord around the styler when
not in use. Store in a dry place.
To clean the plates, wipe with a soft cloth
moistened with a solution consisting of a small
amount of hair shampoo in warm water. Wipe
the outside of the styler with a damp cloth, and
dry with a soft cloth.
Sunbeam is a registered trademark. Made in China. Due to
minor changes in design or otherwise, the product may differ
from the one shown in this leaflet. Approved by the
appropriate Electrical Regulatory Authorities. Backed by
Sunbeam‘s 3 Year Replacement Guarantee and National
Service Network.
© Copyright. SUNBEAM CORPORATION LIMITED 2001.
(INCORPORATED IN N.S.W.) A.C.N. 000 006 771
For more information or advice on any Sunbeam products,
contact the Sunbeam Consumer Service Line on 1800 025 059
in Australia. In New Zealand - contact the Sunbeam Office in
Auckland on 09 912 0747.
3
|