TRENDnet Network Card TEW 636APB User Manual

Quick Installation Guide  
TEW-636APB  
H/W: V1.0R  
 
1. Before You Start  
Package Contents  
?TEW-636APB  
?User's Guide CD-ROM  
?Quick Installation Guide  
?AC Power Adapter (12V DC, 1A)  
?1 RJ-45 cable  
Installation Requirements  
?Web Browser: Internet Explorer (5.5 or higher)  
?A computer with a network adapter or wireless adapter properly installed  
?A network Switch or Hub with an available network LAN port  
?A RJ-45 network cable  
?TEW-621PC version 2 or TEW-623PI version 2 (Optional)  
Application  
300Mbps Wireless N  
HotSpot Access Point  
(TEW-636APB)  
Notebook with 300Mbps  
Wireless N PC Card  
(TEW-621PC)  
Workstation with 300Mbps  
Wireless N PCI Adapter  
(TEW-623PI)  
Internet  
Cable/DSL  
Modem  
4-Port Gigabit Firewall Router Workstation with 300Mbps  
(TWG-BRF114)  
Wireless N USB Adapter  
(TEW-624UB)  
300Mbps  
10/100Mbps  
1
 
English  
2. Hardware Installation  
Note: Locate an optimum location for the Access Point. The best place for the  
Access Point is usually at the center of your wireless network. Please connect  
the computer configuring the TEW-636APB to the same switch/hub.  
1. Connect a RJ-45 cable from the  
Switch/Hub to the LAN port of the  
Access Point.  
2. Connect the AC Power Adapter to  
the Access Point and then to a  
power outlet.  
3. Verify that the following panel lights  
are on: Power and WLAN.  
2
 
English  
3. Configure the Access Point  
Note: It is recommended that you configure the Access Point from a wired  
computer.  
1. Open your web browser, type  
http://SCXXXXXX, in the Address  
bar, and then press Enter.  
XXXXXX represents the last 6  
digits of the Mac Address. You can  
find the Mac Address on the bottom  
of the router.  
2. Enter the User name and  
Password, and then click OK.  
User Name: admin  
Password: password  
3. Click System and then click Basic  
Settings. Select your country or  
domain from the drop down menu,  
click Fixed IP Address, and type in  
an IP address, Subnet Mask,  
Gateway, and DNS to match your  
current network settings. Click  
Save.  
3
 
English  
4. Click Wireless and then click  
Basic Settings. Select the desired  
Wireless Mode, select Access  
Point for Operating mode and then  
click Save.  
5. Click Virtual APs. Select a Virtual  
AP, click Enable and then click  
Configure.  
Note: The example below is for WPA-PSK security. If your wireless adapters  
do not support WPA-PSK, then select WEP.  
6. Enter a SSID, select the desired  
Security System, enter the  
Network Key, click Save and then  
click Back.  
7. Repeat step 5 and 6 for each  
subsequent Virtual AP.  
8. Click Management and then click  
Admin Login.  
4
 
English  
9. If desired, enter a new user name,  
check Change Admin Password,  
enter a new password, retype the  
new password and then click Save.  
By default:  
User Name: admin  
Password: password  
10. Click Apply and then click  
Reboot.  
Note: If you skip this step, any  
settings that you changed will  
NOT be saved.  
Your installation is now complete.  
For detailed information regarding the TEW-636APB’s configuration and  
advanced settings, please refer to the User's Guide included on the Driver CD-  
Register Your Product  
To ensure the highest level of customer service and support, please take a moment to  
register your product Online at: www.trendnet.com/register  
Thank you for choosing TRENDnet  
5
 
English  
Troubleshooting  
message says “The page cannot be displayed.” How can I get into the TEW-  
636APB's web configuration page?  
A1: First, check your hardware settings again by following the instructions in  
section 2. Second, make sure the LAN and WLAN lights are lit. Third, verify the  
Mac Address of the access point. Look at the bottom of the access point. Copy  
the last six digits of the Mac Address. Then open up your browser and type in  
then Enter. Fourth, perform a factory reset. Take a pin or paperclip, press on the  
reset button for 15 seconds, and then let go.  
Q2: All the settings are correct, but I can not make a wireless connection to the  
Access Point.  
A2: First, double check that the WLAN light on the Access Point is lit. Second,  
power cycle the Access Point. Unplug the power to the Access Point. Wait 15  
seconds, then plug the power back in. Third, contact the manufacturer of your  
wireless network adapter. Make sure the wireless network adapter is configured  
with the proper SSID. The default SSID of the Access Point is wireless 0. If you  
have enabled any encryption on the Access Point, make sure to configure the  
wireless network adapter with the same Pre-shared key. If you do not remember  
the encryption key, log on to the access point configuration page from a wired  
computer. Click Wireless -> Virtual AP. Click on the desired Virtual AP and then  
click Configure.  
If you still encounter problems or have any questions regarding the TEW-636APB,  
please contact TRENDnet's Technical Support Department.  
6
 
Certifications  
This equipment has been tested and found to comply with FCC and CE Rules.  
Operation is subject to the following two conditions:  
(1) This device may not cause harmful interference.  
(2) This device must accept any interference received. Including interference that may  
cause undesired operation.  
Waste electrical and electronic products must not  
be disposed of with household waste. Please  
recycle where facilities exist. Check with you Local  
Authority or Retailer for recycling advice.  
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV  
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS  
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO  
OPERATE THE EQUIPMENT.  
ADVERTENCIA  
En todos nuestros equipos se mencionan claramente las caracteristicas del adaptador de  
alimentacón necesario para su funcionamiento. El uso de un adaptador distinto al  
mencionado puede producir daños fisicos y/o daños al equipo conectado. El adaptador  
de alimentación debe operar con voltaje y frecuencia de la energia electrica domiciliaria  
existente en el pais o zona de instalación.  
 
Customer Support  
Email:  
.
.
.
.
.
Europe (Germany France Italy Spain Switzerland UK)  
Toll Free Telephone: +00800 60 76 76 67  
English/Espanol - 24/7  
Worldwide  
Telephone: +(31) (0) 20 504 05 35  
English/Espanol - 24/7  
Product Warranty Registration  
Please take a moment to register your product online.  
20675 Manhattan Place  
Torrance, CA 90501  
USA  
 
Copyright ©2008. All Rights Reserved. TRENDnet.  

TDK Network Card HHM Series HHM1589D1 User Manual
Technicolor Thomson Camcorder 5400LDK User Manual
TeleAdapt MP3 Player Mini MP3 Player User Manual
Thermador Convection Oven SEM272 User Manual
Thermo Products Furnace OL6FA072D48B R User Manual
Tripp Lite Switch B021 000 17 User Manual
Uniden Cordless Telephone XCAI680 User Manual
Uniden Scanner UBC 70XLT User Manual
Warwick Stereo Amplifier 153 User Manual
Weed Eater Blower 952711937 User Manual