Timex Clock 75071T User Manual

Instruction Manual  
®
Intelli-Time Digital Clock  
model 75071T  
CONTENTS  
Troubleshooting ..................... 5  
Care & Maintenance.............. 6  
Replace Intelli-Time Battery ... 6  
Specifications......................... 6  
FCC Information .................... 6  
Customer Support.................. 7  
Warranty............................... 7  
Unpacking Instructions ........... 2  
Package Contents .................. 2  
Product Registration ............... 2  
Features & Benefits................. 3  
Clock Setup........................... 4  
®
®
Intelli-Time Clock .................. 4  
Set the Time & Date ............... 5  
Using the Clock...................... 5  
Questions? Contact Customer Support at  
(877) 221-1252 or visit www.AcuRite.com.  
SAVE THIS MANUAL FOR FUTURE REFERENCE.  
 
Features & Benefits  
1
2
3
4
®
1. Intelli-Time Clock  
9. TIME ZONE Button  
10. RESET Button  
2. AM/PM Indicator  
3. Time Zone Indicator  
4. Daylight Saving Time Indicator  
Full reset to factory defaults  
11. DST OLD/NEW/OFF Switch  
for DST setup preferences.  
5. Integrated Hang Hole  
12. Battery Compartment  
For easy wall mounting.  
®
13. Intelli-Time Battery  
6. SET Button  
7. UP Button  
Compartment  
14. Fold-Out Stands  
8. DOWN Button  
5
6 785 9 10  
5
14  
11 12  
13  
14  
3
 
SETUP  
Install or Replace Batteries  
1. Remove the battery compartment cover.  
2. Insert 4 x AA alkaline batteries into the battery compartment, as shown.  
Follow the polarity (+/-) diagram in the battery compartment.  
3. Replace the battery cover.  
Install or Replace Batteries  
4 AA alkaline batteries  
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE  
WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.  
BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment which is not to be  
used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used  
batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire,  
as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge  
non-rechargeable batteries. DO NOT short-circuit the supply terminals.  
Intelli-Time® Clock  
Intelli-Time clock and calendar are pre-programmed to the correct time and  
date, and update automatically for Daylight Savings Time. All you need to do  
is select your time zone using the “TIME ZONE” button.  
4
 
Set the Time & Date  
Set the time zone (HAST, AKST, PST, MST, CST, EST, AST) by pressing the  
“TIME ZONE” button, located on the back of the clock. The Time Zone  
selected is indicated on the clock display.  
Set the Daylight Saving Time preference (NEW, OLD, OFF) using the DST  
switch, located on the back of the clock. If you live in an area that observes  
Daylight Savings Time, DST should be set to "NEW", even if it is not currently  
Daylight Savings Time. While DST is being observed, "Daylight ST" is indicated  
on the clock display.  
Press and hold the “SET” button for 3 seconds to enter SET MODE. Once in  
SET MODE the preference you are currently setting will blink on the clock.  
To adjust the currently selected (flashing) item, press and release the “UP” or  
“DOWN“ buttons (press and HOLD to fast adjust).  
To save your adjustments, press and release the "SET" button to adjust the next  
preference. The preference order is as follows:  
CLOCK HOUR (Please note AM/PM indicator)  
CLOCK MINUTE  
CALENDAR MONTH  
CALENDAR DATE  
CALENDAR YEAR  
You will automatically exit SET MODE if no buttons are pressed for 15 seconds.  
Enter SET MODE any time by pressing and holding "SET" button for 3 seconds.  
OPERATION  
Using the Digital Clock  
To view the MONTH/DATE/YEAR, press and release the "SET" button. Press  
"SET" button again to display time. If no buttons are pressed after 15 seconds  
the display will automatically display time again.  
Troubleshooting  
• Reset the unit by pressing the reset button located on the  
Clock is too dark,  
back of the clock. This will reset the clock to the original  
hard to read or  
factory settings. Time and date will need to be entered  
after a reset.  
doesn’t work  
If your AcuRite product does not operate properly after trying  
(877) 221-1252 for assistance.  
5
 
Care & Maintenance  
Clock Care  
Clean with a soft, damp cloth. Do not use caustic cleaners or abrasives. Keep  
away from dust, dirt and moisture. Clean ventilation ports regularly with a  
gentle puff of air.  
Replace Intelli-Time Clock Battery  
Intelli-Time technology is powered  
by a pre-installed coin-cell battery  
that stores the time and date  
settings. The battery has a shelf  
life of several years. To replace  
the Intelli-Time battery:  
1. Locate the coin cell battery  
compartment door on the back  
of the display unit. Unscrew and  
remove the compartment cover.  
2. Insert 1 x CR2032 coin cell battery into the battery compartment, as shown.  
Install battery with “+” positive terminal facing right.  
3. Screw in the battery cover.  
Specifications  
POWER  
4 X AA alkaline batteries  
FCC Information  
This device complies with part 15 of FCC rules. Operation is subject to the following two conditions:  
1- This device may NOT cause harmful interference, and  
2- This device must accept any interference received, including interference that may cause undesired operation.  
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the  
user’s authority to operate the equipment.  
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the  
FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This  
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruc-  
tions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a  
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by  
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:  
• Reorient or relocate the receiving antenna.  
• Increase the separation between the equipment and the receiver.  
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.  
• Consult the dealer or an experienced radio/TV technician for help.  
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment.  
Such modifications could void the user authority to operate the equipment.  
This device complies with Industry Canada licence-exempt RSS standard(s).  
Operation is subject to the following two conditions:  
(1) This device may not cause interference, and  
(2) This device must accept any interference received, including interference that may cause undesired operation of the device.  
6
 
Customer Support  
AcuRite customer support is committed to providing you with best-in-  
class service. For assistance, please have the model number of this  
product available and contact us in any of the following ways:  
(877) 221-1252  
24/7 support at www.AcuRite.com  
Installation Videos  
Instruction Manuals  
Replacement Parts  
Register your Product  
Support User Forum  
Submit Feedback & Ideas  
PRODUCT MUST BE REGISTERED  
TO RECEIVE WARRANTY SERVICE  
IMPORTANT  
PRODUCT REGISTRATION  
Register online  
to receive 1 year  
warranty protection  
www.AcuRite.com  
Register a Product  
Limited One Year Warranty  
warranty will not be breached, and Chaney will give no credit  
for products it manufactures which have received normal wear  
and tear, been damaged (including by acts of nature), tampered,  
abused, improperly installed, damaged in shipping, or repaired  
or altered by others than authorized representatives of Chaney.  
At AcuRite, we proudly uphold our commitment  
to quality technology. Chaney Instrument Co.  
warrants that all products it manufactures to  
be of good material and workmanship, and to  
be free of defects when properly installed and  
operated for a period of one year from the date  
of purchase.  
The above-described warranty is expressly in lieu of all other  
warranties, express or implied, and all other warranties are  
hereby expressly disclaimed, including without limitation the  
implied warranty of merchantability and the implied warranty  
of fitness for a particular purpose. Chaney expressly disclaims  
all liability for special, consequential or incidental damages,  
whether arising in tort or by contract from any breach of this  
warranty. Some states do not allow the exclusion or limitation  
of incidental or consequential damages, so the above limitation  
or exclusion may not apply to you. Chaney further disclaims all  
liability from personal injury relating to its products to the extent  
permitted by law. By acceptance of any of Chaney’s products,  
the purchaser assumes all liability for the consequences arising  
from their use or misuse. No person, firm or corporation is  
authorized to assume for Chaney any other liability in connection  
with the sale of its products. Furthermore, no person, firm or  
corporation is authorized to modify or waive the terms of this  
paragraph, and the preceding paragraph, unless done in writing  
and signed by a duly authorized agent of Chaney. This warranty  
gives you specific legal rights, and you may also have other  
rights which vary from state to state.  
We recommend that you visit us at  
your product. However, product registration  
does not eliminate the need to retain your  
original proof of purchase in order to obtain  
warranty benefits.  
Chaney Instrument Co. warrants that all products it manufactures  
to be of good material and workmanship, and to be free of  
defects when properly installed and operated for a period of  
one year from the date of purchase. Remedy for breach of this  
warranty is limited to repair or replacement of the defective  
item(s). Any product which, under normal use and service, is  
proven to breach the warranty contained herein within ONE  
YEAR from date of sale will, upon examination by Chaney,  
and at its sole option, be repaired or replaced by Chaney.  
Transportation costs and charges for returned goods shall  
be paid for by the purchaser. Chaney hereby disclaims all  
responsibility for such transportation costs and charges. This  
For in-warranty claims: Chaney Instrument Co.  
965 Wells St., Lake Geneva, WI 53147  
7
 
Weather  
Stations  
Temperature  
& Humidity  
Weather  
Alert Radio  
Kitchen  
Thermometers  
& Timers  
Clocks  
It’s more than accurate, it’s  
AcuRite offers an extensive assortment of precision instruments,  
designed to provide you with information you can depend on to  
Plan your day with confidence.  
www.AcuRite.com  
©Chaney Instrument Co. All rights reserved. AcuRite is a registered trademark  
of the Chaney Instrument Co., Lake Geneva, WI 53147. All other trademarks and  
copyrights are the property of their respective owners. AcuRite uses patented  
Printed in China  
75071T INST 022614  
 

Taylor Thermometer 9867 User Manual
Teac Garbage Disposal SDU50 User Manual
Technika Model Vehicle 23 230 User Manual
Toshiba Projection Television 46H83 User Manual
Toshiba Projection Television 51H93 User Manual
Triarch Indoor Furnishings 23102 User Manual
Tripp Lite Network Cables DB9F RJ45 User Manual
Viking Burner F20921B User Manual
Vivotek Security Camera PZ8111 User Manual
Walker Indoor Furnishings WQ52C4DRTB User Manual