W-34-US 472-095002
THANK YOU FOR PURCHASING YOUR TIMEX WATCH.
EXTENDED WARRANTY
Available in U.S. only. Extend your warranty for an additional 4 years from date of purchase
for $5. You can pay with AMEX, Discover, Visa or MasterCard by calling 1 800-448-4639 during
normal business hours. Payment must be made within 30 days of purchase. Name, address,
telephone number, purchase date, and 5-digit model number required. You can also mail a
check for $5 to: Timex Extended Warranty, P.O. Box 1676, Dept. EF, Little Rock, AR
72203.
Please read instructions carefully to understand how to operate your Timex watch.
Your model may not have all of the features described in this booklet.
FEATURES
• Date and time display • Daily alarm • 24-hour countdown timer • Chronograph • Hourly chime
BASIC OPERATIONS
SET/
RESET
INDIGLO
START/
STOP
MODE
Press MODE to cycle through TIME, CHRONO, ALARM, and TIMER modes. Press INDIGLO to
illuminate watch face. In any mode, press MODE to view time display. Press any button to stop
alarm or timer beeps.
TIME AND DATE
A. Press and hold SET/RESET. HOURS digits will flash.
B. Press START/STOP to advance digits. Go through 12 hours for AM or PM.
C. Press MODE to select MINUTES.
D. Press START/STOP to advance.
E. Repeat to set MONTH, DATE, DAY, CHIME on or off ( indicates chime is on), 12- or 24-hour
time display, DAY-MONTH or MONTH-DAY date display.
F. Press SET/RESET when done.
CHRONOGRAPH
A. Press MODE until CHRONO appears.
B. Press START/STOP to start.
C. Press START/STOP to pause.
D. Press START/STOP to resume.
indicates chrono is on.
E. When timing is stopped, press SET/RESET to reset chrono.
ALARM
A. Press MODE until ALARM appears.
B. Press and hold SET/RESET to select HOURS. Digits will flash.
C. Press START/STOP to advance digits. Go through 12 hours for AM or PM.
D. Press MODE to select MINUTES.
E. Press START/STOP to advance. Press SET/RESET when done.
F. Press START/STOP to turn alarm on or off.
indicates alarm is on.
When alarm time is reached, watch will beep for 20 seconds, or until any button is pushed.
Alarm will repeat every 24 hours until deactivated.
TIMER
A. Press MODE until TIMER appears.
B. Press SET/RESET to select HOURS. Digits will flash.
C. Press START/STOP to advance.
D. Press MODE to select TENS of MINUTES. Press START/STOP to advance.
E. Repeat to set MINUTES, TENS of SECONDS, and SECONDS.
F. Press SET/RESET when done.
G. Press START/STOP to start timer.
indicates timer is on.
H. Press START/STOP to pause, press again to resume.
I. When timer is stopped, press SET/RESET to reset timer to the beginning.
J. Press and hold SET/RESET to set new countdown time.
Watch will beep when countdown ends.
INDIGLO® NIGHT-LIGHT WITH NIGHT-MODE® FEATURE
A. Press INDIGLO to activate light.
Electroluminescent technology used in the INDIGLO® night-light illuminates watch face at
night and in low light conditions.
B. Press and hold INDIGLO for three seconds (beep will sound) to activate or de-activate
NIGHT-MODE® feature.
C. While in NIGHT-MODE® feature, press any button to illuminate watch face for 3 seconds.
WATER AND SHOCK RESISTANCE
If your watch is water-resistant, meter marking or (
) is indicated.
Water-Resistance Depth
p.s.i.a.* Water Pressure Below Surface
30m/98ft
50m/164ft
100m/328ft
60
86
160
*pounds per square inch absolute
WARNING: TO MAINTAIN WATER-RESISTANCE, DO NOT PRESS ANY BUTTONS UNDER
WATER.
1. Watch is water-resistant only as long as lens, push buttons and Vectora LH Boldcase remain
intact.
2. Watch is not a diver watch and should not be used for diving.
3. Rinse watch with fresh water after exposure to salt water.
4. Shock resistance will be indicated on the watch face or caseback. Watches are designed to
pass ISO test for shock resistance. However, care whould be taken to avoid damaging crystal.
|