Battery installation and charging
Set number of rings
Install the battery as shown below. Once you have installed the
battery, you may be able to make and receive short calls. For best
performance, charge the handset battery continuously for at least
16 hours.
You can set the answering system to answer an incoming call
after 2, 3, 4, 5 or 6 rings; or toll saver. If you choose toll saver,
the answering system answers a call after 2 rings when you
have new messages, or after 4 rings when you have no
new messages.
2
Quick start guide
1
Place the battery with the
wires inside the battery
compartment.
Plug the battery connector
securely into the socket.
1. Press MeNU when the handset is not in use.
2. Scroll to answering sys then press SeLeCT.
3. Scroll to ans sys setup then press SeLeCT.
4. Scroll to # of rings then press SeLeCT.
CS6120-2/CS6124
5. Press CID or
to choose 6, 5, 4, 3, 2 or Toll saver and
Introduction
then press SeLeCT to save.
This quick start guide provides you with the basic installation
instructions. A limited set of features are described in
abbreviated form.
record your own announcement
You can use the preset announcement to answer calls, or replace it
with your own recorded announcement. The announcement can be
up to 90 seconds in length.
Please refer to the online user’s manual for complete installation
and operation instructions.
3
4
Slide the battery
Charge the handset in the
telephone base or charger.
1. Press MeNU when the handset is not in use.
2. Scroll to answering Sys then press SeLeCT twice.
3. Press 7 to record.
Telephone base and charger installation
Install the telephone base and charger as shown below.
compartment cover towards
the center of the handset
until it clicks into place.
Telephone wall jack
Electrical outlet
4. After the handset announces, “Record after the tone. Press 5
when you are done,” speak towards the handset microphone.
(not controlled by
a wall switch)
Charge light
remains on
when charging.
A DSL filter
5. Press 5 when done.
(not included)
is required if
you have DSL
high-speed
6. Press 2 to play the recorded announcement; or 7 to record
again if desired. Press 3 to delete the recorded announcement.
Press 5 to stop the playback at any time.
Telephone base
power adapter
Charger
adapter
Internet service
Telephone
line cord
Charger
enter the handset menu
Telephone base
1. Press MeNU when the phone is not in use.
2. Press CID or
until the screen displays the desired
Use only the power adapters and batteries supplied with
this product.
feature menu.
3. Press SeLeCT to enter that menu.
• To return to the previous menu, press CaNCeL.
• To return to idle mode, press and hold CaNCeL.
IMPOrTaNT!
Set date and time
Refer to the online user’s manual for a full set of installation and
operation instructions. For manual download or customer service,
or call 1 (800) 267-7377.
1. Press MeNU when the handset is not in use.
2. Scroll to Settings then press SeLeCT.
3. Scroll to Set date/time then press SeLeCT.
4. Use the dialing keys (0-9) to enter the current month, date and
year. Then press SeLeCT.
Copyright © 2011 for VTECH TELECOMMUNICATIONS LTD.
All rights reserved. Printed in China.
96-007701-050-100
5. Use the dialing keys (0-9) to enter the hour and minute. Then
press CID or
to select aM or PM.
6. Press SeLeCT to save.
|