Front
Stardance Front
w/Doors Package
Stardance Firebox and
Stove Shell/Door
Installation Instructions
for Models:
SDFBVT/SDFBVTC,
SDFBDVR/SDFBVRC
Right Door
CAR208
Left Door
Fig. 2 Carton contents for operable door package.
CAUTION: Handle porcelain enamel castings gen-
tly. The finish is fragile and can be easily dam-
aged. Place castings on a towel, carpet or other
protective surface.
Assembly Instructions
1. Attach the rear skirt to the left side by aligning the
key holes with the two wingbolts in the side. If nec-
essary, turn the wingbolts to orient the blades verti-
cally. (Fig. 3) Slide the skirt downward to engage it
behind two washers on the side plate bolts and then
tighten both wingbolts.
To complete installation of your Stardance gas stove,
you must first assemble the outer cast shell. Follow
the directions for each model. Refer to Homeowner’s
Manual for complete installation instructions.
Side
Rib
Unpacking the Shell
Wingbolt
The Stardance shell is comprised of three cast iron
plates plus the front with operable doors. The top plate
for the top vent models is a single piece. The top plate
for the rear vent models has three (3) pieces, the plate,
screen and grate. Compare parts recieved with those
shown in Figures 1 & 2. Carefully inspect all parts and
immediately report any damaged or missing parts to
your dealer/distributor.
Left
Side
Steel
Tabs
Stardance Rear
Vent
Wingbolt
Grate
Screen
ST470
Rear Skirt
Stardance
Top Vent
Fig. 3 Attach rear skirt to the left side.
Top
2. Attach the right side to the rear skirt. (Fig. 4) Move
this assembly close to the stove’s final position. Align
the two sides at right angles to the back panel as
shown in Figure 5.
Left Side
NOTE: The firebox is shipped with three bolts and
spacers on the bottom to prevent any damage to
the bottom assembly. The two front bolts should be
removed after installation. Use a 7/16” wrench.
Right Side
CAR207
Fig. 1 Carton contents for Stardance shell.
30004220 7/07 Rev. 0
|