Focusing
NIGHT VISION
Adjust the focusing rings on the front of the lenses plus the rear
eyepieces of the bodyshell until you have the sharpest image.
•
INSTRUCTIONS
WARNING
Lit. #: 06-3650A/3-01
When attached to the 26-1020 Goggle, the lenses convert
the unit into a 3.6x 50mm magnification binocular. THIS
BINOCULAR IS DESIGNED TO BE A HAND-HELD UNIT
ONLY and is not meant to be used head-mounted.
NECK DAMAGE MAY OCCUR IF THIS WARNING IS
DISREGARDED.
WARRANTY / REPAIR
One-Year LIMITED WARRANTY
Your Bushnell® Night Vision is warranted to be free of defects in materials
and workmanship for one year after the date of purchase. In the event of a
defect under this warranty, we will, at our option, repair or replace the
product, provided that you return the product postage prepaid. This
warranty does not cover damages caused by misuse or improper handling,
installation or maintenance of the product.
26-3650A 3.6x50
Lens Accessory
Any return made under this warranty
must be accompanied by the items listed below:
1) A check in the amount of $15.00 to cover the cost of handling
2) Name and address for product return
3) An explanation of the defect
26-3650A LENS
ACCESSORY
Converts the 26-1020 (1.0x20)
Night Vision goggle into a 3.6x
magnification hand-held
binocular
4) Product should be well packed in a sturdy outside shipping
carton to prevent damage in transit and return postage
prepaid to the address listed below:
IN CANADA Send To:
IN U.S.A. Send To:
Bushnell Performance Optics
25A East Pearce Street, Unit 1
Richmond Hill, Ontario L4B 2M9
Bushnell Performance Optics
8500 Marshall Drive
Lenexa, Kansas 66214
For products purchased outside the United States and Canada please
contact your local dealer for applicable warranty information. This warranty
gives you specific legal rights. You may have other rights which vary from
country to country.
Fitting The Lenses
©2001 Bushnell Performance Optics
The 3.6x50mm lenses only fits the Bushnell 26-1020 Night Vision
Goggle.
•
•
•
Detach the standard 26mm lenses from the 26-1020 by turning
counter-clockwise.
Attach the lenses by screwing them, clockwise, into the mounts left
by removing the standard lenses.
26-1020 WITH 3.6X50 LENS ACCESSORY
