Dice electronic Dice Electronics Carrying Case DCR 300 User Manual

1
3
G2 cradle DCR-300/DCR-50 contents  
Disclaimer and warranty  
Important disclaimer, please read!  
Compatible iPod & iPhone  
Unauthorized reproduction or reverse engineering is strictly prohibited! Intellectual property included is distributed under specific license  
agreement with respective owners and is licensed only, not sold. No warranty, explicit or implied, is stated. Neither DICE Electronics, LLC., nor  
any of its agents, distributors, dealers or vendors shall be liable for damages.  
IN NO EVENT SHALL DICE ELECTRONICS' LIABILITY EXCEED THE PRICE PAID FOR THE PRODUCT FROM DIRECT, INDIRECT,  
SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THE PRODUCT, ITS ACCOMPANYING  
SOFTWARE OR ITS DOCUMENTATION.  
For internal use only. Do not submerge or expose to water or other fluids. DICE G2 cradle is NOT water proof and it will be damaged by water.  
You must properly insulate its casing if your installation environment may subject the unit to water, such as a convertible vehicle.  
Keep away from children! DICE G2 cradle can be broken, or disassembled, and components may become loose from vibration and heat.  
Small components and packaging materials may become choking hazard when handled by children.  
Warning! Never place any objects directly into the path of an airbag. DICE Electronics does not accept any responsibility for any damage or  
injury as a result of using this product. Exercise good judgment and keep your eyes on the road at all times!  
DICE logo is a trademark of DICE Electronics, LLC. Kuda is a trademark of KUDA Group. iGrip is a trademark of HR GmbH & Co. KG. ProClip  
is a trademark of ProClip USA Inc. The Made for iPod logo is a trademark of Apple Inc. The Works with iPhone logo is a trademark of Apple Inc.  
Apple iPod is not included in the package.  
DICE G2 cradle  
Universal 5V Cradle for iPod and iPhone  
Model: DCR-50-PTH  
Installation Guide/User Manual  
Table of contents  
Disclaimer and warranty ......................................1  
Compatible iPod & iPhone ...................................2  
G2 cradle contents ...............................................3  
Choose the correct holder ....................................4  
Installation ............................................................5  
Mounting option ....................................................6  
Connect the cradle ...............................................7  
Long base installation ...........................................8  
Adjusting the angle ...............................................9  
DCR-300/DCR-50 cradle  
with regular base and  
iPhone 4 holder x1  
additional holders x6  
long base x1  
Warranty and Support  
If you experience any problems or need help, please contact you local dealer or call DICE Electronics, LLC. At 888-342-3999 or visit us at  
Products carry a 1 year limited warranty that protects you from defects in material and workmanship of products sold by DICE Electronics or its  
authorized agents, distributors and dealers. The warranty period begins the day a product is purchased by the end user. Products found to be  
defective during the warranty period will either be repaired or replaced by DICE Electronics at no charge unless warranty is void. Unauthorized  
attempt of repair or alteration of the product in any way immediately voids this warranty. Warranty does not extend to cosmetics or finish. A DICE  
product specialist must determine that a defect is present in the product and issue an RMA. Be sure that all wiring is connected as described  
in the user manual and all related equipment is functioning properly. DICE Electronics disclaims any liability for other incurred damages  
resulting from product defects. Any expenses in the removal and reinstallation of products are not covered by this warranty.  
PLEASE NOTE: International customers requiring a product replacement, please contact the dealer your product was purchased from!  
4
mounting screws x4  
DCR-300/50 REV. 080510  
6
5
4
Mounting option  
Installation  
These holes are designed to allow you to  
Choose the correct holder  
screw the cradle base to AMPS standard  
mounts (ProClipTM, KudaTM, etc).  
Compatible iPhone/iPod model can be found here.  
Slide the correct holder  
onto the cradle until it  
clicks.  
Slide the iPhone/iPod  
into the holder  
0609r1  
Each holder is designed for a different  
iPhone/iPod model. Identify the holder  
by the printed text on the back of the  
holder and choose the correct holder  
for your iPhone/iPod.  
Use the screws (x4) in the package  
to screw the cradle to AMPS  
standard mounts.  
These holes are designed to fit  
vehicle mounts from iGripTM.  
7
8
9
Connect the Cradle  
Long base Installation  
Adjusting the angle  
To adjust the angle of the cradle, please  
loosen the set screw enough for the cradle  
to move freely. When you are done  
adjusting the angle, hold the base and  
tighten the set screw. DO NOT OVER  
TIGHTEN!  
Attach the iPod dock  
cable into the  
connector on the back  
of the cradle  
If the long base will fit your car interior more appropriately than the short one,  
then please follow the illustration to attach the long base to the cradle. Turn the  
base clockwise to tighten the base to the cradle.  
cable connects  
facing down  
(back view)  
(front view)  
Marking is on the bottom side!  

American Audio American DJ Supply, Inc Car Stereo System 1000 User Manual
ATN 8900 User Manual
Bryan Boilers DST 35 User Manual
Canon Camcorder PC950 User Manual
Canon zr830 User Manual
Casio Fx 9750gii Graphing Calculator FX9750GIIWE User Manual
Farenheit Technologies TID 320T User Manual
FujiFilm 16126002 User Manual
JVC GR AX655 User Manual
JVC GR SXM780A User Manual