JL Audio Stealthbox XC BCS12 25 User Manual

SB-POL-RNGR700 INSTR_SKU# 011295  
InstallatIon  
d I F F I C u lt Y :  
If you choose to perform the installation yourself, it is absolutely vital that the  
Stealthbox  
Slampak® be properly mounted to the vehicle according to these instructions.  
Failure to mount the enclosure properly presents two problems:  
out  
oF  
I n s t a l l a t I o n G u I d e  
for the  
1) The sub-bass performance will suffer due to the movement of the enclosure  
caused by the force exerted by the woofer(s).  
15  
SB-POL-RNGR700  
2) A loose enclosure presents a serious safety hazard in the event of a collision  
or sudden deceleration.  
estImated tIme:  
sKu#94457  
2009+  
1-2 HouRs  
s t e P  
1
Clean off the area around the drivers seat, and the floor  
around the drivers side.  
Remove the seat bottom cusion.  
Thank you for choosing a JL Audio Stealthbox® for your side by side sport utility sound system. With  
proper installation, your new vehicle-specific enclosed subwoofer system will deliver years of listening  
pleasure.  
s t e P  
2
Looking down from the passenger side through the  
opening where the driver would sit. Use the long bolt going  
down through location #1 as reference (see detail below),  
pivot bracket untill the end at #2 is parallel with the outer  
frame rail. Mark the hole at #2 and drill the frame rail.  
#2  
We strongly recommend that you have your new Stealthbox® installed by your authorized JL Audio  
dealer. The installation professionals employed by your dealer have the necessary tools and experience  
to disassemble and reassemble your vehicle properly. Also, keep in mind that your warranty coverage  
extends to 2 years if your system is installed or approved by your authorized JL Audio dealer. If you  
prefer to perform your own installation, please read this installation guide completely  
before beginning the process.  
notice the orientation of the bracket with the hole  
closer to the end being installed towards the frame  
rail.  
#1  
d e t a I l  
#1  
Continued on Next Page  
I n C l u d e d H a R d W a R e  
SB-POL-RNGR700 INSTR_SKU# 011295  
2) Custom Steel Bracket  
2) 3/8-16 x 2 3/4” Hex Head Bolt  
1) 3/8 x 1 1/4” Fender Washer  
4) 5/16 SS Black Washer  
4) 5/16 Steel Split Lock Washer  
3) 5/16-18 Steel Hex Nut  
1) 3/8-16x 1” Hex Head Bolt  
3) 3/8 Split Locking Washer  
2) 5/16-18 x 3/4” Steel Black Cap Screw  
1) 5/16-18 x 3-1/2” Steel Cap Screw  
s P e C I F I C a t I o n s  
Subwoofer Enclosure Type: Acoustic Suspension (sealed)  
Driver Type: M10W5  
Nominal Impedance: 4 Ohms  
Continuous Power Handling: 250 Watts (RMS)  
P o W e R R e C o m m e n d a t I o n  
JL Audio recommends using a high quality amplifier such as the JL Audio M4500. The diagram below shows the  
recommended crossover and input settings for the M4500 when being used to power your Stealthbox® and a pair  
of mids and highs such as the speakers suggested below.  
The JL Audio M4500 is a very versatile audio component. Please consult the owner’s manual for even more  
detailed information about installing and tuning this amplifier.  
C o n n e C t I o n s  
Using quality power, signal and speaker wire is essential in ensuring the performance of your Stealthbox®.  
JL Audio recommends using a 4 AWG power kit such as the XC-PCS4-1B for your Stealthbox® amplifier, other  
kits are available should you be using more than one amplifier. Signal wire such as the JL Audio Premium  
Audio Interconnect Cables should be used that will provide signal for both channels of the amplifier. JL Audio  
reccommends using 12AWG speaker wire for subwoofers such as our XC-BCS12-25.  
m I d / H I G H F R e q u e n C Y d R I v e R F I t m e n t  
A variety of JL Audio coaxial and component systems will fit in the various speaker locations available, we suggest  
using either our MX-650, M-650, M-770 or M-770x speakers to compliment your new Stealthbox®.  
(954) 443-1100  
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered  
trademarks of JL Audio, Inc. “Ahead of the Curveand its respective logo is a trademark of JL Audio, Inc.  
JLA-SKU#011295 ©9-15-2009  
Printed in USA  
©2008 JL Audio, Inc.  
U.S. PATENTS: #5,734,734 #5,949,898 #6,118,884 #6,229,902 #6,243,479  
#6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431 #6,625,292 #D472,891 #D480,709 Other U.S. & Foreign patents pending.  
For more detailed information please visit us online at www.jlaudio.com.  
1
0
3
6
9
N
O
R
T
H
C
O
M
M
E
R
C
E
P
A
R
K
W
A
Y
M
I
R
A
M
A
R
,
F
L
O
R
I
D
A
3
3
0
2
5
U
S
A
Page 3 • JL Audio, Inc 2009  

AMX MODERO VIEWPOINT WIDESCREEN TOUCH PANEL MVP 5200I User Manual
Audiovox Jensen MP5720 User Manual
Audiovox P 975 User Manual
Canon HFM46 User Manual
Canon PSC 60 User Manual
Clarion DXZ666MP User Manual
Eclipse Fujitsu Ten CD4000 User Manual
Emerson Camcorder evc 1800 User Manual
Jensen MP6610 User Manual
JVC Digital Camcorder GZEX210BUS User Manual