Aiwa XP V733 User Manual

Force charging  
BEFORE PLAYBACK  
Inserting a disc D  
1 Slide the OPEN switch to open the disc compartment.  
2 Place a disc in the center with the label side facing up.  
3 Close the disc compartment.  
When recharging stops after only few minutes or the batteries cannot be fully  
recharged, press sSTOP/OFF/CHARGE while pressing PLAY MODE to force  
charging.  
• Do not activate the force charging on the unit when there is no battery inserted  
or when dry cell batteries are inserted. Doing so may cause malfunction.  
B
A
YUC  
XP-V733 XP-V710C  
To stop charging  
Press sSTOP/OFF/CHARGE during charging.  
To remove the disc  
Hold the disc at its edge and pick it up while pressing the pivot gently.  
COMPACT DISC PLAYER  
ENGLISH  
Time to replace the batteries  
Replace the batteries with new ones if they lost their capability to charge fully.  
Note  
• The unit may not play a CD-R/RW disc that is recorded on personal computers or  
some kinds of CD-R/RW recorders because of differences in recording platforms.  
• Do not attach any adhesive label to either side (the recordable side or the labeled  
side) of a CD-R/RW disc. It may cause malfunction.  
OPERATING INSTRUCTIONS  
ATTENTION:  
The product you have purchased can be powered by  
nickel cadmium batteries which are recyclable. At the  
end of their useful life, under various state and local  
laws, it is illegal to dispose of these batteries into your  
municipal waste stream.  
8C-HC7-711-01  
011218BMK-U-A  
Printed in China  
HOLD switch E  
Release HOLD. a  
When not using the unit, set HOLD to the hold position. b  
Accidentally pressed buttons will not function.  
If ePLAY/PAUSE is pressed when HOLD is set to the HOLD position, “HOLd”  
flashes in the display.  
Highlighted letters in the text of this manual correspond to the illustrations.  
OWNER’S RECORD  
USING ON DRY CELL BATTERIES A  
Open the battery compartment and insert two size AA (LR6) alkaline  
Please call 1-800-289-2492 for information on how to  
recycle these batteries.  
For your convenience, record the model number and the serial number (you will  
find it inside the battery compartment of your set) in the space provided below.  
Please refer to them when you contact your Aiwa dealer in case of difficulty.  
batteries with the 0 and 9 marks correctly aligned.  
USING ON AC HOUSE CURRENT  
Connect the optional AC adaptor in the same way as when recharging the  
batteries.  
Turning the power on E  
Press ePLAY/PAUSE.  
Power is turned on and playback starts.  
Battery replacement  
Model No.  
Serial No.  
The battery indicator in the display changes first from  
according to the remaining power of the batteries. Replace the batteries when  
lights. If the unit remains in use after lights, “Lo-bAtt” appears and  
operation stops.  
to  
, then to  
During operation on AC house current, all of the battery indicators turn off.  
Note  
“Err” appears on the display in the following cases:  
–When you try to play the unit without a disc in the disc compartment.  
–When you play a disc placed upside-down or a defective disc.  
NOTE  
This equipment has been tested and found to comply with the limits for a Class  
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed  
to provide reasonable protection against harmful interference in a residential  
installation.  
This equipment generates, uses, and can radiate radio frequency energy and, if  
not installed and used in accordance with the instructions, may cause harmful  
interference to radio communications. However, there is no guarantee that  
interference will not occur in a particular installation. If this equipment does cause  
harmful interference to radio or television reception, which can be determined by  
turning the equipment off and on, the user is encouraged to try to correct the  
interference by one or more of the following measures:  
Battery life (using alkaline batteries LR6)  
D
1
The setting of the E•A•S•S switch  
Battery life  
Approx. 41 hours  
Approx. 30 hours  
Standby mode E  
When an operation finishes, the unit goes into standby mode until the auto power  
off function automatically turns off the power.  
To enter standby mode, press e PLAY/PAUSE to start playback, then press  
sSTOP/OFF/CHARGE.  
48  
12  
Battery life may vary depending on conditions of use.  
If the cover of the battery compartment comes off B  
Turning the power off E  
Press sSTOP/OFF/CHARGE in standby mode.  
• If no new operations are done within 30 seconds from the end of last operation,  
the power is turned off automatically. (Auto power off function)  
Notes on dry cell batteries  
– Reorient or relocate the receiving antenna.  
• Make sure that the 0 and 9 marks are correctly aligned.  
• Do not mix different types of batteries, or an old battery with a new one.  
To prevent the risk of electrolyte leakage or explosions, never recharge the  
batteries, apply heat to them, or take them apart.  
• When not using the batteries, remove them to prevent needless battery wear.  
• If liquid leaks from the batteries, wipe thoroughly to remove.  
– Increase the separation between the equipment and receiver.  
– Connect the equipment into an outlet on circuit different from that to which  
the receiver is connected.  
Adjusting the sound F  
Connect the supplied headphones to the PHONES/LINE OUT jack.  
An amplified speaker system can be connected instead to enjoy the CD sound.  
– Consult the dealer or an experienced radio/TV technician for help.  
2
3
CAUTION  
Volume  
Modifications or adjustments to this product, which are not expressly approved  
by the manufacturer, may void the user’s right or authority to operate this product.  
Press VOLUME+ or - to adjust the volume level.  
DSL  
2
3
C
Hold down PHRASE/DSL for more powerful sound and deeper bass.  
DSL lights up.  
This Class B digital apparatus complies with Canadian ICES-003.  
Hold down PHRASE/DSL again to return to normal playback.  
PRECAUTIONS  
To maintain good performance  
• Do not use the unit in places which are extremely hot, cold, dusty or humid. In  
particular, do not use or keep the unit in following places.  
• in a high humidity area such as a bathroom  
E
F
• near a heater  
• in an area exposed to direct sunlight (e.g., inside a parked car, where it can  
become extremely hot)  
• near sources of strong magnetism, such as televisions, speakers, or magnets  
• where there is a lot of movement or vibration, such as on a car dashboard or  
an unstable shelf  
• Do not open the battery compartment with wet hands.  
• Wipe the unit thoroughly before inserting batteries and after use.  
• Do not soak the unit in water.  
• Before connecting the AC adaptor or the headphones etc., be sure to confirm  
the power is off.  
USING ON RECHARGEABLE BATTERIES C  
• Be sure to use sizeAA Ni-Cd 1.2 V 700 mAh rechargeable batteries, which are  
commercially available.  
• Be sure to read the instructions of the purchased rechargeable batteries before  
use.  
• When using on rechargeable batteries for the first time, charge them until the  
battery indicator goes out.  
For safety  
• Use only an AC adaptor whose rated output is DC 5-6 V, 250-300 mA.  
• Do not attempt to disassemble the unit. Laser rays from the optical pickup are  
dangerous to the eyes.  
• Make sure that pins or other foreign object do not get inside the player.  
Take care not to drop the unit or subject it to strong shocks.  
To keep dust from the pickup lens, keep the disc compartment lid closed after  
use. Never touch the lens.  
• If you hear no sound when playing a disc, DO NOT turn the volume up high  
because music could suddenly start at high volume. Turn the volume control to  
the lowest level before starting playback and slowly turn it up to the desired level.  
• Before charging the batteries, close the disc compartment. You cannot charge  
the batteries while it is open.  
1 Insert the optional rechargeable batteries with the 0 and 9 marks  
correctly aligned.  
2 Connect the optional AC adaptor.  
1 to DC 5~6 V jack  
2 to a wall outlet  
3 Keep sSTOP/OFF/CHARGE pressed for about 2 seconds to start  
charging.  
Notes on listening with the headphones  
“C-on” appears and the battery indicator blinks.  
When charging is completed, “OFF” flashes a few times, and the battery  
indicator goes out. Recharging exhausted batteries takes about 6 hours.  
After charging, disconnect the AC adaptor.  
• Listen at moderate volumes to avoid hearing damage.  
• Do not wear the headphones while driving or cycling. It may create a traffic  
hazard.  
You should use extreme caution or temporarily discontinue use in potentially  
hazardous situations, such as walking, jogging, etc.  
• Wear them properly; L is left, R is right.  
Time to recharge the batteries  
Recharge the batteries when  
lights. If the unit remains in use after  
lights, “Lo-bAtt” appears and the current operation stops.  
Note on condensation  
If the unit is suddenly moved from a cold place to a warm place, it may result in  
condensation on the pickup lens and malfunction or playback difficulties.  
Should this occur, leave the unit for a few hours, then try playback again.  

Nokia 3660 User Manual
LG Electronics LG Lifes Good Cell Phone A133CH User Manual
Kalorik Team International Group Coffeemaker USK CM 34128 User Manual
Huawei Technologies Cell Phone U8815N User Manual
HP Hewlett Packard AutoRAID 12H User Manual
Hamilton Beach 43324 User Manual
FUNAI Blu ray NB530SLX User Manual
Follett VERSION 600 User Manual
Curtis CR4966 User Manual
Clarion BD159RG User Manual