SAT2510U2E
SAT2510BU2E
Instruction Manual
Serial ATA Hard Drive
Enclosure
2.5” eSATA/USB External Hard
Drive Enclosure for Serial ATA
Hard Drives
Table of Contents
Introduction..................................................................... 1
Packaging Contents.....................................................................1
System Requirements.................................................................1
Installation....................................................................... 2
Hardware Installation...................................................................3
Driver Installation.........................................................................4
Verifying Installation.....................................................................5
How to Use ...................................................................... 5
Specifications.................................................................. 7
Technical Support........................................................... 8
Warranty Information...................................................... 8
i
Introduction
This External Hard Drive Enclosure transforms most 2.5” SATA hard
drives into a cost-effective portable storage solution . The 2.5” SATA
hard drive enclosure connects to a host computer using USB 2.0
or eSATA with support for data transfer rates of up to 3Gbps (using
eSATA) or 480Mbps (through USB 2.0).
Packaging Contents
• 1 x SAT2510U2E or SAT2510BU2E enclosure
• 1 x eSATA cable
• 1 x USB cable
• 1 x Driver CD
• 1 x Instruction Manual
System Requirements
• Available USB 2.0 or eSATA port on computer system
• Microsoft Windows® 2000/XP/Server 2003/Vista (32/64-bit),
Mac OS® X, Linux®
1
Installation
Power
connector
eSATA
USB Power/Activity
LED
WARNING: Hard drives require careful handling, especially when
being transported. If you are not careful with your hard disk, lost data
may result. Always handle your hard drive and storage device with
caution.
WARNING: Hard drives, like all computer equipment can also be
severely damaged by static electricity. Be sure that you are properly
grounded before opening your computer case or touching any
components. StarTech.com recommends that you wear an anti-static
strap when installing any computer equipment. If an antistatic strap
is unavailable, discharge yourself of any static electricity build-up by
touching a large grounded metal surface (such as the computer case)
for several seconds.
2
Hardware Installation
1. Remove the screws from the enclosure, and remove the rear panel
cover. Pull the front panel out of the enclosure:
2. Attach the 2.5” SATA hard drive to the connector provided:
3. Insert the front panel (with drive attached) into the rear panel
(enclosure).
3
4. Fasten the front panel (with drive attached) to the rear panel
(enclosure), using the screws removed in step #1.
5. To connect the hard drive enclosure to a host computer using USB,
simply insert the included USB cable into the USB type Mini B slot
provided by the enclosure, and the remaining end into an available
USB type A slot on the host computer.
6. To connect the hard drive enclosure to a host computer using
eSATA, simply plug the included eSATA cable from the enclosure to
the host computer. To provide power to the enclosure, connect the
USB to DC cable (provided) to an available USB port on the host
computer, and insert the remaining end into the power port located
on the hard drive enclosure.
Driver Installation
Windows 2000/XP/Server 2003/Vista, Mac OS X, Linux
No driver installation is required for these operating systems, as this
enclosure is natively supported, so the drivers are already installed.
4
Verifying Installation
Windows 2000/XP/Server 2003/Vista
From the main desktop, right-click on “My Computer” (“Computer” in
Vista), then select Manage. In the new Computer Management window,
select Device Manager from the left window panel.
Double-click on the “Disk Drives” option. A new disk drive should be
listed under this category. It will typically contain the make/model of
the hard drive you have installed in the enclosure.
How to Use
Windows 2000/XP/Server 2003/Vista
1. Right-click on My Computer, and select Manage.
2. Select Disk Management, in the left pane. In the right pane, you
should notice the new hard drive:
5
3. Right-click on the Unallocated block, and select New Partition.
4. This will launch the New Partition Wizard. Please follow the
instruction provided by the Wizard, to partition the drive for use.
5. Once the partition has been created, the drive installed within the
hard drive enclosure will be recognized as a New Volume in Disk
Management, as well as in My Computer:
6
Specifications
USB 2.0
SATA 3Gb/s
Bus Interface
1 x USB mini B
1 x eSATA port
External Connectors
1 x DC power connector
JMircon JM20316
1 x Power/Activity
USB: 480 Mb/s
eSATA: 3 Gb/s
Chipset
LEDs
Maximum Data Transfer Rate
Hard Drive Compatibility
2.5” SATA 1.5 and 3 Gb/s hard
drives, 9.5mm height
Dimensions
Weight
133.0 mm x 72.0 mm x 13.0 mm
90 g
Compatible Operating
Systems
Windows 2000/XP/Server 2003/
Vista, Mac OS X, Linux
7
Technical Support
StarTech.com’s lifetime technical support is an integral part of our
commitment to provide industry-leading solutions. If you ever need
our comprehensive selection of online tools, documentation, and
downloads.
Warranty Information
This product is backed by a one year warranty.
In addition, StarTech.com warrants its products against defects in
materials and workmanship for the periods noted, following the initial
date of purchase. During this period, the products may be returned
for repair, or replacement with equivalent products at our discretion.
The warranty covers parts and labor costs only. StarTech.com does
not warrant its products from defects or damages arising from misuse,
abuse, alteration, or normal wear and tear.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA
LLP (or their officers, directors, employees or agents) for any damages
(whether direct or indirect, special, punitive, incidental, consequential, or
otherwise), loss of profits, loss of business, or any pecuniary loss, arising
out of or related to the use of the product exceed the actual price paid
for the product. Some states do not allow the exclusion or limitation of
incidental or consequential damages. If such laws apply, the limitations
or exclusions contained in this statement may not apply to you.
8
StarTech.com has been making “hard-to-find easy” since 1985,
providing high quality solutions to a diverse IT and A/V customer
base that spans many channels, including government, education
and industrial facilities to name just a few. We offer an unmatched
selection of computer parts, cables, A/V products, KVM and Server
Management solutions, serving a worldwide market through our
locations in the United States, Canada, the United Kingdom and
Taiwan.
our products and to access exclusive interactive tools such as the
Cable Finder, Parts Finder and the KVM Reference Guide.
|