Tripp Lite DVI SINGLE LINK ACTIVE EXTENDER B120 000 SL User Manual |
Owner’s Manual
DVI Single Link Active Extender
Model: B120-000-SL
1111 W. 35th Street, Chicago, IL 60609 USA
Package Contents:
• B120-000-SL DVI Single Link Active Extender
Product Features:
• Supports a maximum video resolution of 1920 x 1080 @ 60Hz
• Extend a DVI-D video signal up to 150 ft. from the source
• Built-in Equalization control to adjust the video image
• HDCP compliant
• External Power Supply
(Input: 100-240V, 50/60Hz, 0.5A Output: 5V, 2A)
• Screwdriver for Equalization Adjustment
• Owner’s Manual
Installation
Note: Test to make sure the entire installation works properly before pulling cables through ceilings/walls.
2
3
1
MONITOR
COMPUTER
B120-000-SL
1
Connect the longer DVI-D Single Link cable between the source and the connector on the B120-000-SL labeled “Source.”
Note: For extension distances 100 ft. or more, use 24Awg DVI-D Single Link cable.
2
3
Connect the external power supply to the B120-000-SL, and then plug it into a Tripp Lite Surge Suppressor, Uninterruptible Power Supply
(UPS), or Power Distribution Unit (PDU). The Green LED will illuminate to indicate that the unit is receiving power.
Connect the shorter DVI-D Single Link cable between the monitor and the connector on the B120-000-SL labeled “Display.” The Orange
LED will illuminate to indicate that there is an active signal between the source and the monitor.
Note: The DVI-D Single Link cable connecting the monitor to the B120-000-SL must be no longer than 16 ft. (5 m.).
4
If necessary, use the equalization control to adjust the video image.
Note: An improper Equalization setting can result in no image being displayed at all. If no image is displayed on your monitor, try adjusting the Equalization.
Copyright © 2011 Tripp Lite. All rights reserved.
|