Aiphone Intercom System JA DGV User Manual

1206  
Vandal Resistant Color Pan Tilt Video Door Station  
- INSTALLATION INSTRUCTIONS -  
FLUSH MOUNTING INSTRUCTIONS  
1. Cut a hole in the wall that is 9-1/16" x 6-1/8". (Ensure  
that mounting depth of at least 2-11/16" is available.)  
2. Pass cable through knockout holes.  
3. Secure back box to wall so that front of box is flush with  
the outside edge of the wall.  
4. Connect wires to the JA-DGV. (See wiring diagram)  
5. Attach the JA-DGV to the mounting box using the  
supplied screws and tamper proof tool.  
JA-DGV  
SURFACE MOUNTING INSTRUCTIONS (REQUIRES SBX-DGV, SOLD SEPARATELY)  
1. The SBX-DGV is designed to mount to a 1 or 2 gang  
box or ring or to any flat surface.  
2. Pass cable through knockout holes.  
3. Secure mounting box to wall.  
4. Connect wires to the JA-DGV. (See wiring diagram)  
5. Attach the JA-DGV to the mounting box using the  
supplied screws and tamper proof tool.  
SBX-DGV  
JA-DGV  
SAMPLE WIRING DIAGRAM  
JA-2MCD  
JA-2MECD  
Mic  
1A1  
1A2  
A1  
A2  
Speaker  
Call  
2A1  
2A2  
B1  
B2  
+
A1  
A2  
Button  
JA-DGV  
JA-DAC  
PS-2420UL  
+
-
-
Pg. 1  
 
SPECIFICATIONS  
Power Source:  
Consumption:  
Picture element:  
Supplied by master station.  
370mA (max.) 4.5mA (Standby, approximate)  
CCD camera  
Image view area  
(approx.):  
Vertical Horizontal  
In horizontal position:  
When pan-and-tilted:  
18"  
3'  
26"  
6'  
Min. illumination:  
Ambient temperature:  
Wiring:  
Less than 1 Lux (at 20" from camera).  
14° F ~ 140° F.  
2 parallel wires, non-polarized to master. PE Insulated, low capacitance.  
Use Aiphone wire # 871802  
Wiring distance:  
AWG  
Distance  
22AWG  
165'  
18AWG  
330'  
Dimensions: (HxWxD)  
Mounting:  
10-3/16" x 7-5/16" x 5/8" (outer panel dimensions)  
Flush mount: 9-1/16" x 6-1/8" x 2-11/16" (ABS plastic back box is included)  
Surface mount with SBX-DGV: 10-3/8" x 7-7/16" x 3-¼” (top), 2-½” (bottom)  
Weight (approx.):  
1.90lbs  
FCC Class B Verification  
NOTE: This equipment has been tested and found to comply with the limits for a  
Class B digital device , pursuant to Part 15 of the FCC Rules. These limits are  
designed to provide reasonable protection against harmful interference in a  
residential installation. This equipment generates, uses, and can radiate radio  
frequency energy and, if not installed and used in accordance with the instructions,  
may cause harmful interference to radio communications. However, there is no  
guarantee that interference will not occur in a particular installation. If this  
equipment does cause harmful interference to radio or television reception, which  
can be determined by turning the equipment off and on, the user is encouraged to  
try and correct the interference by one or more of the following measures:  
— Reorient or locate the receiving antenna.  
— Increase the separation between the equipment and receiver.  
— Connect the equipment into an outlet on a circuit different from that to  
which the receiver is connected.  
— Consult the dealer or an experienced radio/TV technician for help.  
Note:  
Only information pertaining to the connection and operation of the JA-DGV and devices interfacing with it are  
included here. For complete installation, wiring, and operational information about the JA system, please refer  
to the Installation Manual included with the monitor.  
Aiphone Communication Systems  
1700 130th Ave. N.E.  
Bellevue, WA 98005  
(425) 455-0510  
FAX (425) 455-0071  
TOLL FREE TECHNICAL SUPPORT:  
Pg. 3  
JA-DGV instr.  
1206JD  
(800) 692-0200  
 

Addonics Technologies Computer Drive AESN5DA35 User Manual
Addonics Technologies Computer Hardware ADSA3GPX8 ML User Manual
Agilent Technologies Cable Box 8590 User Manual
Airlink101 Network Card AWLL5025 User Manual
Allied Telesis Switch AT GS900 24 User Manual
Audiovox Remote Starter APS 687N User Manual
Avenview Switch VGA C5 SP 12 User Manual
Axis Communications Marine Safety Devices A 120 V AC User Manual
Axis Communications Security Camera P3346 V User Manual
Beko Refrigerator D 9420 NMK User Manual