American DJ DJ Equipment Quadra Force Sys User Manual

American DJ  
®
User Instructions  
QUADRA FORCE/SYS  
CAUTION! Read instructions before installing or plugging unit in.  
DO NOT mount near any flammable surface -- Operate in well ventilated area.  
SPECIFICATIONS:  
QUADRA FORCE™”  
HALOGEN LAMP WARNING!  
This fixture is fitted with halogen lamps  
which are highly susceptible to dam-  
age if improperly handled. Never  
touch lamp with bare fingers as the oil  
from your hands will shorten lamp life.  
Also, never move fixture until lamp has  
had ample time to cool. Remember,  
lamps are not covered under warranty  
conditions.  
Weight:  
Size:  
Lamp:  
Fuse:  
Supply Voltage:  
Working Position:  
Colors:  
9lbs. (master), 8lbs. Slaves  
6"H x 11.5"W x 12.75"L  
EXY 82V 250W  
10A GMA  
120V  
Any Safe position  
Multiple Dichroic Colored  
Moonflower Effect  
Operating Instructions:  
The Quadra Force/SYS is designed to operate as a complete 4-unit lighting system, consisting of 1 master and 3  
slave units. Each lightweight unit is a multi-dichroic rotating moonflower effect, projecting a different gobo in  
multiple beams of rich color. The three slave units plug directly into the master to perform a sound-activated  
chasing light show.  
Verify Package Contents:(1) Master Unit - Equipped with three AC input jacks on the rear panel  
(3) Slave Units - Each equipped with one AC input jack on the rear panel (3) Computer-style AC cords of varied  
lengths. Once the three slaves have been connected to the master, plug the master unit into a standard 110V  
power supply. Each unit has been lamped and is ready for operation. Turn the knob on the rear panel of the  
master to adjust for the desired level of audio sensitivity. Note: If the audio sensitivity is turned all the way down  
or if there is no sound, the units will not chase; instead, the effect will remain fixed on one unit, which will cause  
overheating and damage to that unit.  
To focus a unit, loosen the two Phillips screws on the bottom panel which hold the lens in place. Slide the lens  
forward or backward until you achieve proper focus. Tighten screws.  
Caution! Never open unit when in use. Always disconnect main power before serving or replacing lamp.  
Always replace with same lamp and fuse.  
Lamp Replacement  
Unplug the unit and allow it to cool down. Remove finger screw on the top panel and its attached door.  
Remove the bad lamp from the socket and slide it up through the retaining clips. Replace lamp, being careful  
not to touch lamp with bare fingers. Reassemble.  
Please fill out and send the enclosed warranty card to ensure proper registration of this product. Contact your  
authorized American DJ dealer for service.  
®
American DJ . Los Angeles, CA. 90058 USA  
 

Adams Burner Mark 10 User Manual
Adcom Home Theater System GTP 870HD User Manual
ADTRAN Network Router 3430 User Manual
AEG Freezer A62900GSW0 User Manual
Alto Shaam Oven MN 29491 User Manual
Atmel Computer Hardware AT91CAP7A STK User Manual
Audiovox Automobile Electronics 128 8601 User Manual
Axis Communications Printer AS 400 User Manual
Axis Communications Security Camera AXIS 216FD User Manual
Axis Communications Security Camera P3343 User Manual