American DJ DJ Equipment S 100A User Manual

®
American DJ  
User Instructions  
S-100A™  
STROBE  
Thank you for purchasing this  
American DJ® product. For your  
convenience this strobe light has  
been lamped and is ready to be used,  
there is no assembly required.  
Caution! Always disconnect from main  
power before replacing lamps or servicing unit.  
Remember to always replace with same lamps  
and fuses.  
Please  
read  
the  
following  
instructions before installing or  
using your new unit.  
Operating Instructions:  
Unit is ready to be hung or set on the ground.  
After plugging in unit, the light can be controlled by  
the strobe flash adjustment pot on the rear of the  
strobe. The S-100A™ is a 45W strobe, including  
mounting bracket and control signal input and  
output for linking up to four S-100A’s. For use with  
the S-10A™, S-4A™, or the S-2A™ remote  
controls. To link strobes use a 1/4” to 1/4” mono  
cable.  
Model:  
S-100A™  
SPECIFICATIONS:  
Lamp: ZB-45  
Power: 110V/60Hz  
Working Position: Any  
Weight: 7 lbs.  
To replace lamp; Unplug unit. Unscrew front two  
screws and remove front plastic. Take out lamp,  
replace with a new lamp, then reassemble. Do not  
take the metal housing apart, strobes retain HIGH  
VOLTAGE inside. There are no serviceable parts  
inside.  
Size: 9” x 9 “ x 9”  
For service contact you local American DJ ®  
Dealer.  
LOS ANGELES, CA. 90058  
American DJ ®  
 

3M Mouse EM 550GPL User Manual
Acer Projector PD116 User Manual
ADC Network Card 500L User Manual
AGFA Computer Drive 1236U User Manual
Agilent Technologies Portable Generator 83622B User Manual
Allied Telesis Network Card AT iMG646MOD User Manual
American DJ DJ Equipment Fire Bowl User Manual
Asus Car Video System VN248 Series User Manual
Asus Car Video System VN289QL User Manual
Behringer Stereo Amplifier AMP800 User Manual