®
Outdoor Patio Heater
Wheel Assembly Kit
Hardware
Component
A
B
C
Wheel Bolt
2 pcs
2 pcs
2 pcs
5/16” - 18 x 15 Stainless Steel Hex Head Bolt
Wheel Nut
5/16” - 18 Stainless Steel Hex Nut
Wheel Washer
8 mm Stainless Steel Washer
1. Wheel Assembly . . . . . . . . . . . . . . . . . . . . . 56-01-378
Attach wheel assembly during heater assembly
Step
Note: Attach wheel assembly to base prior to attaching the weight plate.
A. Attach wheel assembly to base using 2 sets of wheel bolts (A), wheel washers (C) and wheel nuts (B).
B. Continue heater assembly in Owner’s Manual.
1
Attach wheel assembly after heater is assembled
A. Lay heater on its side. Be careful not to damage your dome. Support the post on a box or other sturdy item.
B. Remove weight plate, if needed.
C. Attach wheel assembly to base using 2 sets of wheel bolts (A), wheel washers (C) and wheel nuts (B).
D. Reassemble weight plate, if removed.
E. Stand heater upright.
A
C
B
Manufactured in China for:
Blue Rhino Global Sourcing, LLC
104 Cambridge Plaza Drive, Winston-Salem, NC 27104 USA
© 2005 Blue Rhino Global Sourcing, LLC. All Rights Reserved
Endless Summer® is a Registered Trademark of Blue Rhino Global Sourcing, LLC. All Rights Reserved
WK-INS-100 E
|