Bogen Speaker ASUG1DK User Manual

Amplified Speakers  
Models AS1, ASUG1(DK), and ASWG1(DK)  
Installation and Use Manual  
Description  
Bogen’s self-amplified ceiling speakers are 8-inch, cone-type loudspeakers, complete with built-in amplifier and volume  
control knob.  
Power  
Requirements Rating  
Power  
Model  
AS1  
Style  
Mounting Accessories  
Unmounted Cone Speaker with 1W Amplifier and  
Volume Control  
Grilles: CG8A, CG8AW,  
SG8W, PG8A, PG8U, PG8W  
ASUG1,  
ASWG1  
AS1 Mounted onto Steel Ceiling Grille (PG8U or PG8W)  
with Fixed, Volume Control Knob  
1 CU  
1W  
(50 mA)  
TB8, RE84, MR8  
ASUG1DK,  
ASWG1DK  
AS1 Mounted onto Steel Ceiling Grille (PG8U or PG8W)  
& Detachable Volume Control Knob  
Installation Instructions for ASUG1(DK) and ASWG1(DK)  
Note: Do not mount the speaker near noise generating equipment (fans, motors, etc.) and do not use where a normal  
conversation cannot be conducted.  
TB8 and RE84 Installation  
1. Place ceiling tile with the finished side facing up over a large  
trash can (to provide support and save cleanup time).  
2. Cut hole in the center of the ceiling tile, using the raw speak-  
er as a guide.  
3. Bend (4) horseshoe tabs upward on tile bridge.  
4. Position the tile bridge on the unfinished side of the ceiling tile  
and bend (4) locator tabs into tile opening to prevent sliding.  
5. Slip tie-off tabs (2) through RE84 tie-off tab slots until they  
click into place and secure customer-supplied “tie-off” wire to  
tab.  
6. Punch out knockout in the RE84. Install listed metallic enclo-  
sure entry fitting to knockout to accommodate plenum cable  
or plenum. Whip and feed cable or whip through the knock-  
out.  
7. Install RE84 to tile bridge by orienting horseshoe tab slots (4)  
over horseshoe tabs (4) of bridge.  
8. With pliers, twist horseshoe tabs (4) of tile bridge 1/2 turn,  
securing enclosure to bridge.  
9. Screw the Ceiling Speaker assembly to the RE84 using (4)  
8-32 screws provided with the Ceiling Speaker assembly,  
sandwiching the TB8 and ceiling tile in between. The screws  
must go through the TB8 clearance holes as shown. (Screws  
anchor into the RE84.)  
© 2004 Bogen Communications, Inc.  
All rights reserved.  
Specifications subject to change without notice.  
54-5850-02C 0804  
 

Bissell Vacuum Cleaner 79T3 User Manual
BodyCraft Home Gym GXP User Manual
Braun Lawn Mower 790cc 4 User Manual
Brother Cassette Player PT 1200 User Manual
Casio Battery Charger HA A34AT User Manual
Casio Calculator ClassPad 300 User Manual
Casio Calculator FX300ESPLSTP User Manual
Casio Cash Register PCR T470 User Manual
Cecilware Coffeemaker BT3 User Manual
Chief Manufacturing Indoor Furnishings KWK 110 User Manual