Breville Hot Beverage Maker URN10 User Manual

Breville is a registered trademark of Breville Holdings Pty. Limited  
ABN 98 000 092 928  
Breville Customer Care Centre  
Locked Bag 2000  
Botany NSW 2019  
Australia  
Customer Service  
(02) 9384 9601  
Ph: 1300 139 798  
¤
Fax  
Email Customer Service  
Breville Customer Service Centre  
Private Bag 94411  
Greenmount  
Auckland, New Zealand  
Customer Service  
0800 288 513  
Ph: 09 271 3980  
¤
Fax  
Email Customer Service  
PRINTED ON  
RECYCLED PAPER  
© Copyright. Breville Holdings Pty. Limited 2004  
INSTRUCTIONS FOR USE  
MODEL URN6/URN10  
Due to continual improvements in design or otherwise, the product you  
purchase may differ slightly from the one illustrated in this booklet.  
Model URN6/URN10  
Issue 2/00  
 
OPERATING YOUR BREVILLE URN  
OPERATING YOUR BREVILLE URN (CONTINUED)  
BEFORE FIRST USE  
It is recommended that before the first use,  
the Urn is filled to the maximum level, boiled  
and water discarded.  
NOTE!  
NOTE!  
1. Firstly fully unwind power cord from base.  
2. Place the Urn on a dry level surface and  
position the drip tray at the front of the  
Urn (tilt the Urn back and slide the drip  
tray under to secure in place fig 1).  
4. After filling the Urn, ensure that the lid is  
replaced and locked into position.  
5. Plug the power cord into a 230/240V  
power outlet and switch on. The red ‘on’  
light will illuminate.  
6. Turn the variable heat control to ‘Hi’ for  
fast boiling (fig 3). The heating light will  
remain on.  
Fig 4  
When the unit has boiled, select the  
desired setting from ‘Low’ to 7 to  
maintain temperature. The heating light  
will illuminate on and off maintaining the  
temperature selected.  
Fig 1  
3. To fill with water, turn the locking lid anti-  
clockwise and remove (fig 2). Use a  
smaller container to fill the Urn between  
the minimum and maximum marks. Too  
little water will result in the Urn switching  
off before the water has boiled.  
Fig 5  
8. After use, switch the appliance to off,  
switch the power off at the power outlet  
and then remove the plug when the  
appliance is not being used and before  
cleaning.  
Fig 3  
7. To pour hot water, place a cup in the drip  
tray and push the non-drip tap down  
(fig 4). For continuos pouring, lift the tap  
in the vertical position (fig 5).  
Fig 6  
Lock  
Unlock  
Fig 2  
4
5
 
SAFETY BOIL DRY PROTECTION  
CARE AND CLEANING  
The Urn is fitted with a safety device which  
protects against overheating should the  
appliance be operated with insufficient water  
or has boiled dry. If this occurs, the Urn will  
stop heating. Both the red and orange lights  
will turn off.  
Always switch the appliance to off, switch  
the power off at the power outlet and then  
remove the plug before cleaning. Never  
immerse the Urn controls or cord in water,  
or allow moisture to come in contact with  
these parts.  
Switch the appliance to off, switch the  
power off at the power outlet and allow the  
Urn to cool. Press the safety reset button  
under the base before refilling (fig 7). The  
safety device will then be reset and the Urn  
is ready for use.  
REMOVAL OF MINERAL DEPOSITS.  
Mineral deposits in tap water may cause the  
Urn interior to discolour. This may be  
removed by using a commercial kettle  
descaler which is available from most  
leading supermarkets, departments and  
hardware stores.  
Fig 7  
TO CLEAN THE POLISHED  
EXTERIOR.  
The stainless steel surface may be wiped  
over with a damp cloth and polished with a  
soft dry cloth.  
NOTE!  
6
7
 

Beko Washer WMP6315 User Manual
Bock Water heaters Electric Heater Commercial Oil Fired Water Heaters User Manual
Bosch Appliances Smoke Alarm FMM 7045 User Manual
Caldera Cooktop SSK305LP C User Manual
Califone Cassette Player 3132PLC User Manual
Canon Projector LV 7325U User Manual
Cardinal Gates Safety Gate MG25 User Manual
Carrier Air Conditioner T 298 User Manual
Casio Clock TQ 131U User Manual
Cateye Bicycle Accessories CC VL800 User Manual