9" Lighted, Fogless Shower Mirror
InstallIng the batterIes
• Unscrew the BATTERY COMPARTMENT DOOR latch,
then lift and squeeze the latch to remove the DOOR.
• Insert 4 AA batteries according to polarity indicators inside
the battery compartment.
• Replace the BATTERY COMPARTMENT DOOR by sliding the
two tabs into the slots, snapping the latch down and replacing
the screw securely to ensure a water-resistant seal.
usIng the mIrror
• Peel protective film from mirror face before first use.
Note: Do not attempt to reapply the protective film to the mirror
as this may compromise the anti-fog feature.
• Insert included RAZOR HOLDER into the slot on the bottom
of the rim, directly under the POWER BUTTON, prongs facing
out from the wall.
• Attach the Mirror to your shower wall using the included SUCTION
CUPS. Press the Mirror firmly to a smooth, clean, non-porous
surface. Moistening the SUCTION CUPS before mounting may
provide a stronger hold. If the surface is tile, avoid placing the suction
cups over grout.
• Press the POWER BUTTON once to turn the lights on. The lights will
turn off automatically in 10 minutes, or press the POWER BUTTON
a second time to turn them off manually.
Note: Do not fully submerge unit in water.
Care and maIntenanCe
To avoid scratching, clean only with a soft, wet cloth or a non-abrasive
household degreaser. Let mirror surface air dry.
battery preCautIons
• Dispose of the old batteries properly. Do not dispose of the old
batteries in a fire.
• Do not leave the batteries where a child or pet could play with
or swallow them. If the batteries are swallowed, contact a
physician immediately.
• The batteries may explode if mistreated. Do not attempt to recharge
or disassemble the batteries.
• Use only fresh batteries of the required size and type. Do not mix
old and new batteries, different types of batteries, or rechargeable
batteries of different capacities.
608364
608364_INS_Lighted Fogless Shower Mirror
Instructions Doc. Size: 4"W x 7"H
Output at 100% Prints 1/1 Black
|