Form No. 2000
(4/04)
BRYAN STEAM
Heat Exchanger Type Pool Heater
Outputs from 200,000 to 4,200,000 BTUH Water Heat Source
and 400,000 to 3,600,000 BTUH Steam Heat Source
Features:
•Completelypackaged
and assembled
• No gas or oil piping required
• No vent or chimney required
• Lower initial cost
Standard Equipment
Steel heat exchanger shell — (125 PSI-ASME), copper
heat exchanger with brass head, pool water tempera-
turecontrolaquastattocontrolheatsourcecirculating
pump or steam control valve, assembled and wired.
Optional Equipment
Circulatingpump,steamcontrolvalve,thermometer,
• Less space required
steam pressure gauge, steam strainer.
All of the features and quality of the time proven
Bryan “Indirect” Heaters are now available using
an existing central boiler heating plant as the
heat source.
Hot water or steam is taken from the heating
main and circulated through the exchanger
shell. The pool water is heated as it passes
through the copper “Indirect” coil.
Note
1. Steam valve sizing based upon 5 PSI minimum
steam pressure and ½ PSI return pressure.
2. Pumpsizingbaseduponmaximumtemperature
drop through exchanger of 30° F, and maximum
head loss in piping between boiler and heater of
10 ft. H20. For other conditions and pressure drop
data consult factory.
|