MA0602-EA
Operation Guide 4726
I Timekeeping second hand moves in 2-second increments
when power is low.
10
Hour hand
• To set the time
50
Minute hand
I For a watch with an elapsed time bezel
2 0
• To adjust the positions
Rotate the elapsed time bezel to align the
minute hand.
After certain amount of time elapsed, read the graduation on
the elapsed time bezel which the minute hand points to.
The elapsed time is indicated.
mark with the
4 0
First click
(Setting day)
3 0
of the alarm dial and
the stopwatch hands
1. Pull the crown out to the second
click when the second hand is
at 12 o’clock position and the
second hand stops.
2. Set the hands by rotating the
crown. Rotate the crown to
move the hands clockwise.
Move the minute hand four or
five minutes past the time you
want to set, and then back it up
to the proper setting.
• Carefully set the time, making
sure to distinguish between
AM and PM.
Elapsed time bezel
Second click
(Setting time)
• Some water resistant models are equipped with a screw lock
crown.
Crown
(Normal position)
• With such models, you must unscrew the crown in the
direction noted in the illustration to loosen it before you can
pull it out. Do not pull too forcibly on such crowns.
• Also note that such watches are not water resistant while
their crowns are loosened. Be sure to screw the crowns
back in as far as they will go after making any setting.
Second hand
Day
Alarm hour hand
Alarm minutes hand
3. Use B to adjust the alarm dial hands to the current time.
• Each press of B advances the alarm time by one minute.
• Holding down B advances the alarm time at high speed.
4. After adjusting the alarm dial hands, hold down A for about two seconds.
• The stopwatch minute hand will perform one revolution automatically at this time.
5. When the stopwatch minute hand stops at 60 (12 o’clock), advance to step 6.
• If the stopwatch minute hand is not pointing at 60 (12 o’clock) when it stops, use
B to adjust its position so it does.
• Each press of B advances the hand by one minute.
• Holding down B advances the hand at high speed.
6. After adjusting the stopwatch minute hand, hold down A for about two seconds.
• The stopwatch 1/5-second hand will perform one revolution automatically at this
time.
7. When the stopwatch 1/5-second hand stops at 12 o’clock, advance to step 8.
If the stopwatch 1/5-second hand is not pointing at 12 o’clock when it stops,
use B to adjust its position so it does.
• Each press of B advances the hand by 1/5-second.
• Holding down B advances the hand at high speed.
8. Push the crown back in to the normal position.
To set the day
1. Pull the crown out to the first click.
2. Set the day by rotating the crown away from you (in the
direction indicated by the arrow in the illustration).
3. Push the crown back in to the normal position.
• Avoid changing the date setting while the current time is
between 9:00 p.m. and 1:00 a.m.
Using the Alarm
Alarm hour hand
Alarm minutes hand
When an alarm is turned on, the alarm tone sounds for about 20 seconds when the
alarm time is reached.
• You can set an alarm time that is within 12 hours from the current time.
• You can set only one Daily Alarm.
To set an alarm time
1. Pull the crown out to the first click.
2. Use B to set the alarm time you want. Each press of B advances the alarm time
by one minute. Holding down B advances the alarm time at high speed.
3. Push the crown back in to the normal position.
To stop the alarm tone
To stop the alarm tone after it starts to sound, press any button.
• After the alarm sounds, the hands of the alarm dial will move to the current time
position.
To cancel a previously set alarm time
1. Pull the crown out to the second click.
• This will cause the hands of the alarm dial to move automatically to the current
time setting.
2. Push the crown back in to the normal position.
Using the Stopwatch
Stopwatch minute hand
Stopwatch 1/5-second hand
The stopwatch lets you measure elapsed time up to 59 minutes, 59.80 seconds.
To measure times with the stopwatch
Elapsed Time
Stop
Split
Re-start
Stop
Stop
Clear
Clear
Start
Split Time
Start
Split release
1
|