Model 971LM Security✚® Single Button Remote Control
OWNER’S MANUAL
The 900 Series remote control works only with door openers
WARNING
To prevent possible SERIOUS INJURY or DEATH from a moving
gate or garage door:
and light controls having an orange “learn” button. The code
between the remote control and the receiver changes with each
use, randomly accessing over 100 billion new codes.
• ALWAYS keep remote controls out of reach of children. NEVER
permit children to operate, or play with remote control
transmitters.
Instructions are Described and Illustrated Below
• Activate gate or door ONLY when it can be seen clearly, is properly
adjusted, and there are no obstructions to door travel.
• ALWAYS keep gate or garage door in sight until completely closed.
NEVER permit anyone to cross path of moving gate or door.
9
1
9
1
7
3
7
3
5
5
KG
KG
The Remote Control Batteries
WARNING
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
The lithium batteries should produce
power for up to 5 years. To replace,
pry open case with visor clip or
1. Press and release the “learn” button on
the motor unit. The learn indicator light
will glow steadily for 30 seconds.
Battery
positive
screwdriver, as shown. Insert
side up (+)
batteries positive side up (+).
2. Within 30 seconds, press and hold the
button on the hand-held remote.
Dispose of old batteries properly.
3. Release the button when the motor unit
light blinks. It has learned the code. If
light bulbs are not installed, two clicks will
be heard.
NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of
this receiver and/or transmitter are prohibited, except for changing the code setting or replacing
the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
To Erase All Codes From Motor Unit Memory
To deactivate any unwanted remote, first erase all codes:
Press and hold the “learn” button on motor
unit until the learn indicator light goes out
(approximately 6 seconds). All previous
codes are now erased. Reprogram each
remote or keyless entry you wish to use.
Replacement Parts
3V2032 Lithium battery . . . . . . . . . . . . . . . . . . . . . . . . .10A20
Visor clip . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .29B137
Owner’s Manual - Spanish . . . . . . . . . . . . . . . . .114A2208SP
FOR SERVICE DIAL OUR TOLL FREE NUMBER:
US: 1-800-528-2817
CANADA: 1-800-654-4736
© 2006, Chamberlain Group Inc.
All Rights Reserved
114A2208D
|