™
®
LINEA by HALO
LV211
End Feed
TB216
Terminal Block
For starting a run. Will accept
Surface conduit
Add additional feeds to T-bar or J-box
canopy to create straight, L, T and X
configurations. Terminal block mounts
to mounting plate of LV216.
Finish:
White (P), Black (MB)
Finish:
White (P), Black (MB)
LV212
Straight Joiner
LV218-18 Suspension Stem Kit
For suspending Wireway channel with
18" threaded stem. Allows two #10AWG
wires and can be used to feed wireway
channel.
For connecting two sections.
May also be used as a feed point.
Finish:
White (P), Black (MB)
Finish:
White (P), Black (MB)
LV213
Right-Angle Joiner
TC118
Wireway Cover
For connecting two sections at a
90° angle. May also be used as a
feed point.
Used to cover Wireway for pendant-
and cable-suspended applications.
96" long – can be field cut.
Finish:
White (P), Black (MB)
Finish:
White (P), Black (MB)
LV217-1
T-Bar Clip
LV215
Flexible Joiner
Use with minimal grid (9/16”) systems
To connect two sections at an angle
up to 90° or for connecting wall-and
ceiling-mounted sections. Allows
for continuation of wireway. May
also be used as a feed point.
LV217-2
T-Bar Clip
Use with standard grid (15/16”) systems
Finish:
White (P), Black (MB)
LV216
T-Bar and J-Box
Canopy Feed
LV219
Suspension Cable Kit
Use to suspend wireway channel with 4'
cable that can be adjusted in the field.
For starting a run on a T-bar ceiling
installation. Use with conduit fitting
or with outlet box.
Finish:
White (P), Black (MB)
Finish:
White (P), Black (MB)
DEW210 Dead End for Wireway
Channel
AW1
1/16” Allen Wrench
Used for tightening connector screws. Pack
of 10.
To complete the end of a channel run
(one supplied with channel section).
Pack of 6.
Finish:
White (P), Black (MB)
COOPER LIGHTING
277
|