Insulated
Hand-lift Cabinet
FL-0520-12
Rev. 3 (10/08)
Page 1 of 4
5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
For INSULATED HAND-LIFT CABINET; MODEL H-339214
ELECTRICAL SPECIFICATIONS:
MODEL
Volts
Watts
Amps
Hertz
Phase
NEMA
H-339214
120
900
7.5
60
1
5-15
SWITCH LIGHT
“ON-OFF”
THERMOMETER
THERMOSTAT
DOOR
VENT
FIGURE 1
HOW TO INSTALL UNIT:
HOW TO OPERATE UNIT: (Figure 1)
1. Plug cord into 20-amp wall outlet.
2. Place cabinet in a well ventilated area.
1. Push switch “ON”. Yellow light will come on.
2. Turn thermostat to the temperature you need.
3. Push the switch on, turn the thermostat to No. 10
and run the unit for one hour.
NOTE: No. 7½ setting will give you about 180° F.
Proper food holding temperature is 140° F or
higher.
NOTE: DO NOT PUT IN FOOD!
This step is to burn off manufacturing oils and
excessive adhesive.
3. Preheat cabinet for 45 minutes
4. Put food into cabinet.
4. Let the cabinet cool and wipe inside clean with
detergent and hot water before use.
5. Turn the wing nut on the door vent to open the vent
when less humidity is needed.
To Turn Off Unit:
Push switch “OFF”. The yellow light will go off.
NOTE: Thermometer gives the inside cabinet
temperature.
Insulated
Hand-lift Cabinet
FL-0520-12
Rev. 3 (10/08)
Page 3 of 4
5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
For INSULATED HAND-LIFT CABINET; MODEL H-339214
HOW TO REVERSE DOOR HARDWARE
CABINET
BODY
FOR OPPOSITE HAND (Refer to Fig. 3 [hinge]):
1. Pop off hinge covers with screwdriver.
2. Remove screws from hinges to cabinet; remove door
and unscrew latch strike from cabinet.
DOOR
TOP
3. Remove hinges, latch and all remaining screws from
the right and left side of door. Keep all screws.
4. Re-mount hinges and latch in the same hole pattern on
the opposite sides of the door. Plug all extra holes with
screws.
HINGE
COVER
5. Remove all screws from the front sides of cabinet (not
the top and bottom).
6. Hold door up to cabinet and screw hinges to the
cabinet.
7. Open door and re-mount the latch strike to cabinet.
8. Plug all extra holes with screws and snap on the hinge
covers.
FIGURE 2
REPLACEMENT PARTS
TROUBLE-SHOOTING CHART
Cord Set.................................... H339214-08
Switch....................................... 0808-113
Heater Kit..................................0811-066-K
Thermostat Kit..........................0848-062-K
Terminal Block..........................0852-091
Thermometer.............................5238-030
Door Latch Kit..........................1006-122-01-K
Strike Kit...................................1006-122-02-K
Hinge Kit...................................0519-074-K
Gasket Kit................................. 0861-077
Casters.......................................0569-306
Casters w/Brake........................0569-306-B
Door Replacement Kit.............. 5508-084-SS
Rack Insert................................1170-122
FAILURE
1. Unit does not heat:
POSSIBLE CAUSE/CHECK
1a. Thermostat turned up.
1b. Switch is “ON”.
1c. Cord is plugged into outlet.
1d. Circuit breaker/fuse for
wall outlet
2. Unit will not turn off: 2a. Thermostat turned down.
2b. Switch is “OFF”
If cause is none of the above, refer to our list of
authorized service agencies, FL-1400.
Instructions for replacing parts are included in
replacement parts kits.
Insulated
Hand-lift Cabinet
FL-0520-12
Rev. 3 (10/08)
Page 4 of 4
5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
For INSULATED HAND-LIFT CABINET; MODEL H-339214
|