CXD2000H-NA
U.S.
08/50158/1 (U.S.) Issue 1
Dimplex CXD Ceramic Radiant Heater
Model(s) : CXD2000H-NA
THESE INSTRUCTIONS SHOULD BE READ CAREFULLYAND RETAINED FOR FUTURE REFERENCE
Installation
Important Safety Advice
Heaters are supplied with an integral wall bracket which may be
fixed through the mounting holes to any suitable structure. The bracket
positions the heater at the an angle of 45 degrees for optimum
performance. The recommended fixing height is 1.8m from ground
level - see Fig. 2.
Because the Dimplex Ceramic Radiant Heater contains no
moving parts little maintenance is required. Before
undertaking any maintenance work on the heater due
attention must be paid to the following:
This heater is designed to be horizontally wall mounted
only, it must not be ceiling mounted.
The integral wall fixing bracket may be removed by fully unscrewing
to facilitate its fixing.
Always ensure a safe mounting height, at or above a
minimum height of 1.8 metres from ground level, so that
the heater can not be touched when in operation.
The siting of the heater(s) should be such as to allow an even and
uninterrupted distribution of radiation to the area(s) to be heated.
When deciding upon the best location, consideration must be given
to the following requirements:
The heater must be wall mounted level ± 5º to the
horizontal.
a. Avoid structures which might vibrate e.g. crane gantries.
Do not locate the heater immediately above or below a
fixed socket outlet or connection box.
These could adversely affect element life.
b. Comfort and safety could be compromised unless the heater is
Always disconnect the heater from the electricity supply
before attempting to work on or near it.
mounted at or above 1.8m from ground level.
c. Allow a minimum of 500mm minimum clearance between the
top of the heater and any horizontal surface - see Fig. 1.
Always ensure a safe means of access using an access
tower or properly supported ladder.
Do not cover the heater.
Element Replacement (see Fig. 4)
Keep combustible materials away from the heater.
WARNING – BEFORE UNDERTAKING THIS TASK ENSURE THE
HEATER IS DISCONNECTED FROM THE ELECRICITYSUPPLYAND
LEFT TO COOL FOR A MINIMUM OF 30 MINUTES.
Do not position patio furniture, sunshades, awnings and
other combustible materials too close to the heater.
Do not use heater if the elements are broken - as injury
may occur.
1. The heater should be taken off the wall.
2. Remove 3 screws to remove the rain shield (see ‘a’ in Fig. 4) to
Allow adequate time (minimum of 30 mins.) for the
elements and body casing to cool before attempting to
work on the heater .
gain access to the control box on the back of the heater.
3. Remove 4 screws to remove the terminal block plate (see ‘b’ in
Fig. 4) and disconnect the terminal block.
Wiring between the heater and the spur outlet or isolation
4. Remove 8 screws to remove the control box (see ‘c’ in Fig. 4).
switch must be in
polychloroprene).
a
heat resisting cable (e.g.
5. This will allow access to the elements. Remove the retaining
clips and spring clips (f) to loosen the elements.
Do not install less than 1.8 metres (6 feet) from ground
level.
6. Disconnect the elements from their terminal blocks.
Warning: Please ensure all packaging is removed from
the appliance before switching on.
7. Remove the remaining 5 screws which hold the back panel (see
‘d’ in Fig. 4).
8. Remove the splash brackets (see ‘g’ in Fig. 4) on the elements.
9. Bend the bars on the guard as indicated in Fig. 3 to remove it.
General
10. The old element should drop out through the front of the heater,
reverse the process when replacing with the new element -
Element Replacement Kit No. - FTELLN-1-KIT (Optional).
Your Dimplex Ceramic Radiant Heater uses ceramic elements which
produce a high proportion of their output in the long-wave infra-red.
This provides a high comfort factor – similar to the natural energy
from the sun.
Cleaning and User Maintenance
WARNING: BEFORE UNDERTAKING CLEANING OR MAINTENANCE
WORK ON THE APPLIANCE, DISCONNECT THE ELECTRICITY
SUPPLY.
Electrical
The installation of this appliance should be carried out by a
competent electrician and be in accordance with the current
IEE wiring regulations and any local or insurance regulations.
Since the appliance contains no moving parts little maintenance is
required beyond cleaning and element replacement. It is however
essential that the heater is not operated with an accumulation of
dust or dirt on the element, as this can cause a build up of heat and
eventual damage. For this reason the heater must be inspected
regularly, depending upon conditions and at least at yearly intervals.
Allow adequate time for the element and body casing to cool before
attempting to work on the heater - a minimum time of 30 minutes is
recommended.
The CXD2000H-NA is designed for use on a 230-240V AC single
phase supply.
An all-pole isolating switch with a minimum separation of 3mm in
each pole must be fitted to facilitate isolation. This switch must either
be positioned inside a building or have an IP rating against water
ingress suitable for external installation.
The appliance must be supplied through a residual current device
(RCD) having a rated residual operating current not exceeding 30mA.
The appliance must be connected to a socket-outlet having an earthing
contact.
We recommend that a cable with a minimum specification of H07RN-
F polychloroprene sheathed or similar be used with a minimum
temperature rating of 90°C.
The wiring to the appliance must be connected with a UL approved
watertight connection for outdoor use. Remove rain shield for access
to this connection and then replace rain shield once connection is
completed.Appliance must have rain shield installed at all times during
operation.
Note : Always ensure the cable grip is tightened.
Limited Warranty
•
Dimplex will in its sole discretion either repair or replace such
defective Product or part without charge. If Dimplex is unable to
repair or replace the Product or part, or if repair or replacement
is not commercially practicable or cannot be timely made, Dimplex
may, in lieu of repair or replacement, choose to refund the
purchase price for the Product or part.
Products to which this limited warranty applies
This limited warranty applies to your newly purchased Dimplex
outdoor heater. This limited warranty applies only to purchases
made in any province of Canada except for Yukon Territory, Nunavut,
or Northwest Territories or in any of the 50 States of the USA (and
the District of Columbia) except for Hawaii and Alaska. This limited
warranty applies to the original purchaser of the Product only and is
not transferable.
•
•
Limited warranty service will be performed solely by dealers or
service agents of Dimplex authorized to provide limited warranty
services.
The purchaser is responsible for removal and transportation of
Products excluded from this limited warranty
the Product or part (and any repaired or replacement Product or
part) to and from the authorized dealer’s or service agent’s place
of business.
Products purchased in Yukon Territory, Nunavut, Northwest
Territories, Hawaii, or Alaska are not covered by this limited warranty.
Products purchased in these States, provinces, or territories are
sold AS IS without warranty or condition of any kind (including,
without limitation, any implied warranties or conditions of
merchantability or fitness for a particular purpose) and the entire risk
of as to the quality and performance of the products is with the
purchaser, and in the event of a defect the purchaser assumes the
entire cost of all necessary servicing or repair.
•
•
This limited warranty does not entitle the purchaser to on-site or
in-home services. On-site or in-home services may be performed
at the purchaser’s specific request and expense at Dimplex’s
then-current rates for such services.
Dimplex will not be responsible for, and the limited warranty
services shall not include, any expense incurred for installation
or removal of the Product or part (or any replacement Product or
part) or any labour or transportation costs. Such costs shall be
the purchaser’s responsibility.
What this limited warranty covers and for how long
Products covered by this limited warranty have been tested and
inspected prior to shipment and, subject to the provisions of this
warranty, Dimplex warrants such products to be free from defects
in material and workmanship in respect of the heater components of
the Product for a period of 12 months; and in respect of the heating
elements of the product for a period of 60 days from the date of the
first purchase of the Product.
What Dimplex and its dealers and service agents are
also not responsible for:
IN NO EVENT WILL DIMPLEX, or ITS DIRECTORS, OFFICERS, OR
AGENTS, BE LIABLE TO the PURCHASER OR ANY THIRD PARTy,
WHETHER IN CONTRACT, INTORT, OR ONANYOTHER BASIS, FOR
ANYINDIRECT, SPECIAL, PUNITIVE, EXEMPLARY, CONSEQUENTIAL,
OR INCIDENTALLOSS, COST, OR DAMAGEARISING OUT OF OR IN
CONNECTION WITH THE SALE, MAINTENANCE, USE, OR INABILITY
TO USETHE PRODUCT, EVEN IF DIMPLEX OR ITS directors, officers,
orAGENTS HAVE BEENADVISED OF THE POSSIBILITY OF SUCH
LOSSES, COSTS OR DAMAGES, OR IF SUCH LOSSES, COSTS, OR
DAMAGESARE FORESEEABLE. IN NO EVENTWILLDIMPLEX, or ITS
OFFICERS, DIRECTORS, ORAGENTs BE LIABLE FOR any DIRECT
LOSSES, COSTS, OR DAMAGES THAT EXCEED THE PURCHASE
PRICEOFTHEPRODUCT.
This limited warranty period also applies to any implied warranties
that may exist under applicable law. Some jurisdictions do not allow
limitations on how long an implied warranty lasts, so the above
limitation may not apply to the purchaser.
What this limited warranty does not cover
This limited warranty does not apply to Products that have been
repaired (except by Dimplex or its authorized service representatives)
or otherwise altered. This limited warranty does further not apply to
defects resulting from misuse, abuse, accident, neglect, incorrect
installation, improper maintenance or handling, operation with an
incorrect power source, fire or other circumstance outside of
Dimplex’s control including, without limitation, an Act of God.
SOME JURISDICTIONS DO NOT ALLOW THE EXCLUSION OR
LIMITATION OF INCIDENTALOR CONSEQUENTIALDAMAGES, SO
THEABOVE LIMITATION OR EXCLUSION MAY NOTAPPLY TO THE
PURCHASER.
What you must do to get service under this limited
warranty
Defects must be brought to the attention of Dimplex Technical Service
by contacting Dimplex at 1-888-DIMPLEX (1-888-346-7539), or 1367
Industrial Road, Cambridge Ontario, Canada N1R 7G8. Please have
proof of purchase, catalogue/model and serial numbers available
when calling. Limited warranty service requires a proof of purchase
of the Product.
How State and Provincial law apply
This limited warranty gives you specific legal rights, and you may
also have other rights which vary from jurisdiction to jurisdiction.
The provisions of the United Nations Convention on Contracts for the
Sale of Goods shall not apply to this limited warranty or the sale of
Product covered by this limited warranty.
What Dimplex will do in the event of a defect
In the event the Product or part covered by this limited warranty is
proven to be defective in material or workmanship during, in the One
Year Warranty or 60 Day Warranty period, as applicable, you have
the following rights:
If you have any technical questions regarding the operation of your Ceramic Radiant Heater have your Model and Serial Number ready, and
contact Dimplex North America technical support at 1-888-DIMPLEX (1-888-346-7539) before returning the product to the point of purchase.
1-888-DIMPLEX
1367 Industrial Road
Cambridge, Ontario
1-888-346-7539
Canada, N1R 7G8
Approved for use in the United States and Canada
|