Extron electronic Stereo Receiver WPD 110 A User Manual

WPD Series Wallplates • Installation Guide  
The Extron WPD Series (WPD 110 A, WPD 120 A, WPD 130 A and WPD 140 A) are single  
gang pass-through wallplates with HDMI, DisplayPort, DVI or VGA front connectors and  
pigtail mounted rear connectors. All models can be installed in single gang junction boxes,  
and include a Decora®-style trim plate. The models are as follows:  
DVI  
DISPLAYPORT  
COMPUTER  
A
B
C
A
B
C
A
B
C
A
B
C
e
e
e
e
Side View  
WPD 130 A  
WPD 140 A  
WPD 120 A  
WPD 110 A  
z
z
z
z
WPD 110 A — HDMI, stereo audio, and control  
о
о
о
HDMI female to HDMI female connector on a pigtail  
3.5 mm stereo audio jack with 3-pole captive screw connector  
3-pole captive screw connector (for pass-through signals such as IR and RS-232)  
WPD 120 A — DisplayPort, stereo audio, and control  
о
о
о
DisplayPort female to DisplayPort female connector on a pigtail  
3.5 mm stereo audio jack with 3-pole captive screw connector  
3-pole captive screw connector (for pass-through signals such as IR and RS-232)  
WPD 130 A — DVI, stereo audio, and control  
о
о
о
DVI-I female to DVI-I female connector on a pigtail  
3.5 mm stereo audio jack with 3-pole captive screw connector  
3-pole captive screw connector (for pass-through signals such as IR and RS-232)  
WPD 140 A — VGA, stereo audio, and control  
о
о
о
15-pin VGA female connector on a pigtail  
3.5 mm stereo audio jack with 3-pole captive screw connector  
3-pole captive screw connector (for pass-through signals such as IR and RS-232)  
Install the wallplate directly into the wall using the supplied mud ring or a UL-listed 1-gang  
junction box (not supplied). Follow the steps in the “Installation” section on page 2.  
Planning — Check the Proposed Installation Location  
Before starting the installation it is important that you do the following:  
CAUTION: Risk of Personal Injury. Failure to check the items listed below may result in  
personal injury.  
ATTENTION: Failure to check the items listed below may result in property damage.  
Ensure there are no utility cables or pipes at the intended location that might be  
damaged or cause injury when you are installing the device.  
Check that the installation meets the local and state regulatory requirements, including  
building, electrical, and safety codes, and UL and ADA accessibility requirements.  
c
c
CONTINUED ON PAGE 2  
 

Cisco Systems Network Router 6500 VS User Manual
Craftsman Lawn Mower 917389062 User Manual
Curtis Clock Radio SCR1320 User Manual
EverFocus Security Camera ED560 User Manual
Extron electronic Stereo Amplifier DA SV EQ Series User Manual
FEIN Power Tools Welder FSC 20 SC User Manual
Ford Automobile 2008 Escape User Manual
Frigidaire Clothes Dryer FFRG1001PW User Manual
Frigidaire Oven 318205312 User Manual
Fundex Games Games Heist User Manual