AZ41E09EAC
GE Zoneline® Deluxe Series Cooling and Electric Heat Unit
Wall Case Dimensions
Dimensions and Installation Information (in inches)
Electrical Wiring
Maximum Cord Extension (in inches)
All wiring, including installation of receptacle, must
be made in accordance with local electrical codes
and regulations.
A
Note: Aluminum wiring may pose special problems –
consult a qualified electrician.
C
Grille Options
Stamped Aluminum Grille – RAG60
Exterior Architectural Louvers Durable Polycarbonate:
21
58
B
RAG61 (Beige)
RAG62 (Maple)
RAG63 (Bittersweet)
RAG67 (Extruded Aluminum)
RAB71 Wall Sleeve
Wall Opening Dimensions
Retrofit Kits:
Heavy-gauge galvanized steel, with insulation.
A – 42", B – 13-3/4", C – 16"
Add 1/4" to A and C dimensions for all cut-out size.
RAB71 16-1/4" Min. H x 42-1/4" Min. W
RAK901L – Wall Case Insulation for use with heat pumps.
RAK40 – Deflector Kit to adapt chassis for use with
existing exterior architectural louvered grilles.
RAB71 available in 16", 24", 28" and 31" depths
RAB77 16-1/2" Min. H x 42-3/8" Min. W
RAB77 Wall Sleeve
Molded SMC fiberglass-reinforced polyester
compound.
A – 42-1/8", B– 13-7/8", C – 16-1/4
Ducted Applications
265 Volt Sub-Base Connected Units
4100 and 6100 series can be used with ductwork to heat or cool more than one room. RAK6052
Duct Adaptor is applied to top of case over air discharge/RAK601 Duct Extension is applied
to right or left of adaptor. Locally fabricated ductwork may be added to extend to maximum
recommended distance of 15 feet.
Min. Circuit
Protection
(Amps)
Power
Electric
Electric
Sub-Base Connection Kit Heater Watts Heat Amps
RAK204E15
RAK204E20
RAK204E30
RAK5172
RAK5202
RAK5302
2,550
3,450
5,000
10.3
13.7
19.6
15
20
30
Electrical Connection
230/208 volt units may be plugged into a receptacle. 265 volt units are provided with a junction box
and require direct connection. (NEC Requires 265V Direct Connection) See Architects and Engineers
Design Data Manual for electrical connection information including use of sub-base for direct
connected units. Installation must comply with local electrical codes and regulations.
Power Connection kits required on all Zoneline chassis.
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
ge.com or call GE Answer Center® service,
800.626.2000.
Specification Created 11/09
390592
|