EverFocus Security Camera EZ PLATECAM2 User Manual

EZ-PLATECAM2  
High Contrast Long Range  
License Plate Capture Camera  
INSTALLATION & OPERATION MANUAL  
Before attempting to connect or operate, please read and follow these instructions.  
 
1. Cautions  
This device complies with Part 15 of the FCC Rules.  
Operation is subject to the following two conditions;  
1. This device may not cause harmful interference.  
2. This device must accept any interference received, including  
interference that may cause undesired operation.  
Note -  
This equipment has been tested and found to comply with the limits  
for a Class A digital device, pursuant to part 15 of the FCC Rules.  
These limits are designed to provide reasonable protection against  
harmful interference when the equipment is operated in a commercial  
environment. This equipment generates, uses, and can radiate radio  
frequency energy and, if not installed and used in accordance with  
the instruction manual, may cause harmful interference to radio  
communications. Operation of this equipment in a residential area  
is likely to cause harmful interference in which case the user will be  
required to correct the interference at his own expense.  
WARNING -  
This is a class A product. In a domestic environment this product may  
cause radio interference in which case the user may be required to take  
adequate measures.  
Caution -  
Any changes or modifications in construction of this device which are  
not expressly approved by the party responsible for compliance could  
void the user’s authority to operate the equipment.  
1. An AC24V 1 Amp power supply is recommended for use with this camera  
for the best picture and the most stable operation.  
2. It is recommended that the camera is used with a monitor or other equipment that  
has a CCTV quality 75 video impedance level.  
3. Do not attempt to disassemble the camera to gain access to the internal  
components. Refer servicing to the manufacturer.  
4. Never face the camera towards the sun, any bright, or reflective light that may  
cause smear on the picture or cause possible damage to the CCD.  
5. Do not remove the serial number sticker.  
3
 
1. Cautions  
Correct Disposal of This Product  
(Waste Electrical & Electronic Equipment)  
(Applicable in the European Union and other European countries with  
separate collection systems)  
This marking shown on the product or its literature, indicate that it should not be  
disposed with other household wastes at the end of its working life. To prevent  
possible harm to the environment or human health from uncontrolled waste disposal,  
please separate this from other types of wastes and recycle it responsibly to promote  
the sustainable reuse of material resources.  
This product should not be mixed with other commercial wastes. Contact the  
company where you purchased this product or your local government office for details  
on how to properly dispose or recycle the product to be environmentally safe.  
Business users should contact their supplier and check the terms and conditions of  
the purchase contract.  
Household users should contact the retailer for proper disposal procedures  
.
4
 
2. Features  
• 1/3" Sony Super-HAD CCD  
• OSD Menu system customizes performance to match application  
• High Resolution 600TV Lines  
• Special filter and IR LEDs provide maximum readability  
despite headlight glare  
• Plate capture up to 75mph (120Km/H)  
• 5.0 ~ 50.0mm Vari-focal lens captures license plate  
from 16ft ~ 90ft (5M ~ 28M)  
• IP65 rated weather resistant  
• Cable concealed through bracket  
• AC24V power with auto-polarity  
(DC12V operation requires 1.5 Amp minimum power supply)  
3. Items Provided In The Box  
CAMERA /  
SUNSHIELD  
VIDEO OUTPUT  
TEST CABLE /  
POWER  
PIGTAIL CABLE  
L-WRENCH / SCREW  
Plastic anchors - 4ea  
OPERATION MANUAL  
5
 
Component and Control Names and Functions  
4.  
Sunshield  
Mounting Bracket  
IR LED : 100ea  
External Zoom and Focus adjustments  
Camera Body  
Body Lock Ring  
Base Lock Ring  
Cover to Access Menu Controls and LED Level Control  
Pressing the “SETUP” button prompts the main setup menu.  
“PUSH” button : To access the main setup menu  
“U” Direction : Menu item UP selection  
“D” Direction : Menu item DOWN selection  
“L” Direction : To change data or decrease value  
“R” Direction : To change data or increase value  
LED Level : LED brightness – Adjusting brightness of the LED  
(Factory default setting Level : Max)  
6
 
5. Installation  
• ADJUSTING CAMERA POSITION  
360°  
360°  
90°  
* 1st Axis  
* 2nd Axis  
* 3rd Axis  
Loosen socket head allen screws to change angle  
and/or rotate body about base.  
WARNING !  
To prevent injury, this apparatus must be securely  
attached to the mounting surface with sufficient  
strength to hold the weight of the camera including  
wind and snow loading in accordance with the  
installation instructions.  
7
 
5. Installation  
• CONNECTIONS  
(1) DUAL(DC12V/AC24V)  
Power Supply  
24VAC/ 1 A min. (Recommended)  
12VDC/ 1.5 A min. (Optional)  
DVR OR  
OTHER CCTV  
EQUIPMENT  
HANDHELD  
VIDEO TEST POINT  
CONNECTION  
VIDEO IN  
When you install the camera, please seal the end of cable to  
protect the camera connections from humidity problems.  
8
 
6. OSD Functions  
OSD Menu Structure  
OSD Access  
To access OSD menu unscrew cover plate on bottom of camera, press “in” on  
joystick to access OSD Menu  
.
MODE  
- INSTALLATION  
SETUP  
MODE  
NEG. IMAGE  
EXIT  
Installation Mode provides a bright video  
screen to adjust angle and focus.  
LICENSE-PLATE  
OFF  
- LICENSE-PLATE  
License-plate Mode provides high  
contrast and clear license plate image  
for license plate capture.  
NEGATIVE  
User can select positive or negative image.  
SETUP  
MODE  
NEG. IMAGE  
EXIT  
LICENSE-PLATE  
OFF  
Negative ON  
Negative OFF  
9
 
7. Installation Guidelines  
Camera Height  
Consider camera height in distance calculation.  
Sharper angles will alter the appearance of the plate.  
Shallow angles are recommended)  
(
Camera Height (Ft) Horizontal Distance (Ft) Capture Distance(Ft)  
10  
11  
12  
13  
14  
10  
20  
30  
40  
50  
14.14  
22.83  
32.31  
42.06  
51.92  
10  
 
7. Installation Guidelines  
Camera Angles  
Vertical and horizontal angle must not exceed 30 degrees to  
achieve proper view of the license plate.  
Capture Zone  
Wider angles provide shorter capture distance.  
Tele angles provide longer capture distance.  
WIDE SETTING -66.5o @ f=5mm  
TELE SETTING -7.4o @ f=50mm  
Optimized Capture  
Range for S/W  
License Plate c
recongnizable with eyes  
11  
 
7. Installation Guidelines  
Lane Width  
Narrow lanes = less variation in plate location.  
Wider lanes = more variation in plate location.  
Lens should cover entire width of the lane.  
Ensure horizontal field of view is wide enough.  
Speed  
Camera can capture moving vehicles up to 75mph.  
Keep camera as low as possible.  
Minimize horizontal angle.  
Zoom in the lens as close as possible.  
Up to 75 mph  
12  
 
7. Installation Guidelines  
DVR  
Camera is fully compatible with industry standard DVRs.  
Check compression settings.  
For best results use non-conditional refresh compression.  
(i.e. MJPEG or JPEG)  
(Other Video codecs can sometimes cause an indistinct picture)  
Use D1 (720x480) resolution for best results.  
Use 30fps (each channel) for best results.  
13  
 
8. Specifications  
Signal Format  
Image Device  
Total Pixels  
NTSC  
PAL  
1/3" Sony Super HAD CCD  
811(H) x 508(V)  
768(H) x 494(V)  
795(H) x 596(V)  
752(H) x 582(V)  
Effective Pixels  
Inter. H/V  
15.734KHz(H), 59.94Hz(V)  
15.625KHz(H), 50Hz(V)  
H.Resolution  
Minimum illumination  
S/N Ratio  
600TV Lines  
0 Lux (IR LED ON)  
More than 50dB (AGC Off)  
Internal  
Sync System  
Video Output  
Lens  
1.0 Vp-p Composite(75Ω)  
Varifocal(5~50mm) Auto Iris  
850nm, 100ea  
IR LED  
IP Rating  
IP65  
Speed Rage  
Up to 75mph (120km/h)  
16ft ~ 90ft (5m ~ 28m)  
Maximum 30 degree offset  
14˚F~122˚F(-10˚C ~ +50˚C)  
-4˚F~140˚F(-20˚C ~ +60˚C)  
License  
Plate  
Capture  
Capture Distance  
Capture Angle  
Operating Temperature  
Storage Temperature  
Power  
Consumption  
DC12V ±10% Max 1.5A  
AC24V ±10% Max 24W  
Heater  
Built in Thermostat Control  
Approx. 1800g (3.97lb)  
Weight  
Dimension  
115.2mm x 164.5mm (4.54inch x 6.47inch)  
Specifications and designs are subject to change without notice for improving the functionality of this product.  
14  
 
9. Dimensions  
unit: mm(inch)  
ø110(ø4.33)  
317(12.48)  
115.2(4.54)  
185.85(7.31)  
Ф3.5(Ф0.14)  
90 degree  
Bottom of Bracket  
15  
 
EverFocus Electronics Corp.  
Corporate Headquarters:  
12F, No.79 Sec. 1 Shin-Tai Wu Road,  
Hsi-Chih, Taipei, Taiwan  
TEL: +886-2-26982334  
China Office:  
Room 609, Technology Trade Building,  
Shangdi Information Industry Base,  
Haidian District, Beijing, China 100085  
TEL: +86-10-62973336~39  
FAX: +86-10-62971423  
FAX: +886-2-26982380  
U.S.A - California Office:  
1801 Highland Avenue Units A & B  
Duarte, CA 91010  
U.S.A - New York Office:  
415 Oser Avenue Unit S  
Happauge, NY 11788  
TEL: +1-631-436-5070  
FAX: +1-631-436-5027  
TEL: +1-626-844-8888  
FAX: +1-626-844-8838  
Europe - Germany Office:  
Albert-Einstein-Strasse 1,  
D-46446 Emmerich, Germany  
TEL: +49-2822-93940  
FAX: +49-2822-939495  
Japan Office:  
5F Kinshicho city Building,  
2-13-4 Koto-Bashi,  
Sumida-Ku, Tokyo, 130-0022 Japan  
TEL: +81-3-5625-8188  
FAX: +81-3-5625-8189  
India Office:  
UK Office:  
Suite 803, Housefin Bhavan, C-21,  
Bandra Kurla Complex, Bandra (East),  
Mumbai 400051. India.  
TEL: +91-222-444-8791  
FAX: +91-222-444-8790  
Unit 12 Spitfire Business Park  
Hawker Road  
Croydon, CR0 4WD  
London: 0845 430 9999  
Telford: 0845 430 8888  
Fax: 020 8649 9907  
Ihr EverFocus Produkt wurde  
entwickelt und hergestellt mit qualitativ  
hochwertigen Materialien und  
Komponenten, die recycelt und wieder  
verwendet werden können.  
Dieses Symbol bedeutet, dass  
elektrische und elektronische Geräte  
am Ende ihrer Nutzungsdauer vom  
Hausmüll getrennt entsorgt werden  
sollen.  
Your EverFocus product is designed  
and manufactured with high quality  
materials and components which can  
be recycled and reused.  
This symbol means that electrical and  
electronic equipment, at their end-of-  
life, should be disposed of separately  
from your household waste.  
Please, dispose of this equipment at  
your local community waste  
Bitte entsorgen Sie dieses Gerät bei  
Ihrer örtlichen kommunalen  
Sammelstelle oder im Recycling Centre.  
Helfen Sie uns bitte, die Umwelt zu  
erhalten, in der wir leben!  
collection/recycling centre.  
In the European Union there are  
separate collection systems for used  
electrical and electronic product.  
Please, help us to conserve the  
environment we live in!  
16  
 

Escient Home Theater Server FireBall Media Management system User Manual
Euphonix Music Mixer 840 08758 02 User Manual
EverFocus DVR EMV200 User Manual
Everpure Water Dispenser CB20 302E User Manual
Ford Automobile Parts M 6007 B50 User Manual
Fujitsu Printer FTP 628WSL110 User Manual
Garland Food Warmer 35 KW User Manual
GBC Photo Printer H 950 User Manual
Gitzo Camcorder Accessories GT2941LLVL User Manual
Global Machinery Company Saw LS211 User Manual