Extron electronic Network Card 3G HD SDI 101 User Manual

Setup Guide — 3G HD-SDI 101  
The Extron® 3G HD-SDI 101 cable equalizer compensates  
for signal degradation in coaxial cable and extends Serial  
Digital Interface (SDI) signals up to 500 feet (150 m),  
and High Definition SDI (HD-SDI) or Third Generation  
SDI (3G-SDI) signals up to 400 feet (120 m). It should  
be placed at the end of a long cable run and close to the  
output device.  
These instructions provide  
a quick setup guide for  
experienced installers.  
Installation and service must  
be performed by authorized  
personnel only.  
W
Extron  
UTPUT  
POWER  
12V  
0.4A MAX  
HD-SDI 101  
Cable Equalizer  
INPUT  
Step 1  
400' RG6 Cable  
Turn all the equipment off and disconnect  
all cables.  
HD-SDI Display  
Step 2  
Place the unit on a convenient table top or  
mount it in a rack, under a desk, or on a  
HD-SDI Camera  
projector mounting system. Follow the instructions included with the appropriate mounting  
kit.  
POWER  
12V  
0.2 A MAX  
Step 3  
Connect the external 12 VDC power supply (provided) to the 2-pole captive screw  
power connector. When power is applied to the unit, the front panel LED lights  
green.  
Voltage polarity is important. Identify the negative lead by the ridges on  
the side (see the figure at right).  
C
A
A
Always use a power supply specified by Extron for this unit. Use of an  
unauthorized power supply voids all regulatory compliance certification  
and may cause damage to the supply and the 3G HD-SDI 101.  
C
Ridges  
Smooth  
SECTION A–A  
Step 4  
Connect the cable from the HD-SDI source to the female BNC input connector.  
For SDI signals, the maximum length from the signal source to the 3G HD-SDI 101 input  
is 500 feet (150 m). For HD-SDI signals, the maximum length from the signal source to  
the 3G HD-SDI 101 input is 400 feet (120 m). To obtain maximum cable lengths, Extron  
recommends the use of RG-6 type cable.  
N
Step 5  
Connect the cable from the HD-SDI display device to the female BNC output connector.  
Troubleshooting  
If problems are encountered, verify that the cables are routed and connected properly.  
If the problems persist, contact the Extron Service Department.  
Extron USA-West Extron USA-East Extron Europe  
Extron Asia  
Extron Japan  
Extron China  
Extron Middle East 68-1553-50  
Headquarters  
Rev. A  
+800.633.9876  
+800.3987.6673  
+800.7339.8766  
+81.3.3511.7655  
+400.883.1568  
+971.4.2991800  
Inside USA / Canada Only  
Inside Europe Only  
Inside Asia Only  
Inside China Only  
01 10  
Inside USA / Canada Only  
+1.919.863.1794  
+1.919.863.1797 FAX  
+31.33.453.4040  
+31.33.453.4050 FAX  
+65.6383.4400  
+65.6383.4664 FAX  
+86.21.3760.1568  
+86.21.3760.1566 FAX  
+1.714.491.1500  
+1.714.491.1517 FAX  
© 2010 Extron Electronics. All rights reserved.  
 

Dyson Vacuum Cleaner DC27 User Manual
EDGE Tech Printer QL Series User Manual
Electro Voice Speaker System FRX+660 User Manual
Eton Weather Radio FR600RDS User Manual
Everpure Water System CG53 20S User Manual
Fisher Paykel Cooktop CI604DT User Manual
Fujitsu Server V600 User Manual
Furman Sound Stereo Amplifier MS2A 1 User Manual
GE Freezer FUM21DM User Manual
Giant Automobile Parts GP5136 5100 User Manual