MODEL H6138
1
⁄
2" AIR IMPACT
WRENCH
INSTRUCTION SHEET
EYE INJURY HAZARD!
Always wear safety glasses
during use to prevent
serious personal injury!
INJURY HAZARD!
Always disconnect tool from
air to prevent unexpected
operation during service!
EXPLOSION HAZARD!
Never exceed 120 PSI!
Figure 1. Model H6138.
Introduction
⁄
Quick
Connector
Quick
Connector
Lubricator
Regulator
1
2" drive accepts all 1⁄2" standard and metric sock-
ets. Features pistol grip with trigger switch, for-
ward and reverse switch, 4 clutch settings, rubber
bumpers for protection against normal garage use
and a 1⁄4" NPT male quick connect fitting. Sockets
not included.
Your
Tool
Air
Compressor
Quick
Coupler
Quick
Coupler
Air Hose
Filter
Figure 2. Installing your tool.
Inventory
A. Air Impact Wrench...................................... 1
1
B.
⁄4" NPT Quick Connect Fitting (male)........ 1
Operation
Tool requires 90 PSI to operate correctly.
To improve tool lifespan, use a filter/lubricator/
regulator as shown in Figure 2. Otherwise, lubri-
cate daily with a couple drops of pneumatic tool oil
directly into the air fitting as shown in Figure 3.
Figure 3. Lubricating directly into air fitting.
If you need help with your new pneumatic tool,
call our Tech Support at: (570) 546-9663.
COPYRIGHT © FEBRUARY, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#PC8007 PRINTED IN CHINA
|