LARGE WHEEL NURSERY
PUSH CART
MODEL H3034
INSTRUCTION SHEET
COPYRIGHT © JUNE, 2004 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#CA6393 PRINTED IN CHINA
ASSEMBLY INSTRUCTIONS
4. Slide the handle through the handle housing
When assembling the Model H3034, tighten all
nuts and bolts finger tight, then, when the cart is
assembled, tighten all nuts and bolts firmly.
rings and fasten with M8-1.25 x 40 hex bolts,
and lock nuts for the ends, and M8-1.25 x
16 hex bolts for the threaded housing rings
(Figure 4).
FENCES, HANDLES, AND LEGS
5. Place the support bar in the bracket on the
base and bolt the ends to the legs with M8-
1.25 x 40 hex bolts, flat washers and lock
nuts (Figure 4).
1. Bolt the fence sides to the inside of the base
using the M8-1.25 x 30 hex bolts, flat wash-
ers, lock washers, and hex nuts.
2. Install the tailgate with the hinges facing out,
using the M6-1 x 70 slotted screws and lock
nuts as shown in Figure 3.
6. Secure the support bar in the bracket with a
M8-1.25 x 40 hex bolt, flat washer and lock
nut (Figure 4).
AXLE AND WHEELS
1. With the cart upside down, place the axle
through the axle housing on the bottom of the
base.
2. Place a wheel and a 20mm flat washer on
each axle end.
3. Insert and spread a cotter pin through each
axle.
If you need additional help with this procedure,
call our service department at: (570) 546-9663.
Figure 3. Tailgate hinges.
3. Bolt the legs to the base (Figure 4) using M8-
1.25 x 40 hex bolts, flat washers, and lock
nuts. Bolt them to the sides using M8-1.25 x
45 hex bolts, flat washers and lock nuts.
Figure 4. Leg and handle installation.
H3034 Parts Breakdown and List
1
14, 17, 18
13
5
15, 17, 18
14
16, 17, 18
3
6
4
14,17,18
19, 20
2
7
9
10
11, 12
REF
1
PART#
DESCRIPTION
REF
12
13
14
15
16
17
18
19
20
PART#
DESCRIPTION
PH3034001 FENCE
PH3034002 TAILGATE
PH3034003 HANDLE
PH3034012 COTTER PIN 4MM X 42MM
PB03M
PB15M
PB26M
PB118M
PLN04M
PW01M
PS90M
PLN03M
HEX BOLT M8-1.25 X 16
HEX BOLT M8-1.25 X 40
HEX BOLT M8-1.25 X 30
HEX BOLT M8-1.25 X 45
LOCK NUT M8-1.25
2
3
4
PH3034004 TAILGATE LATCH
PH3034005 SUPPORT BAR
PH3034006 BASE
5
6
7
PH3034007 LEG
FLAT WASHER 8MM
PHLP HD SCR M6-1 X 70
LOCK NUT M6-1
9
PH3034009 WHEEL 26 X 2.125
PH3034010 AXLE
10
11
PW13M
FLAT WASHER 20MM
|