Grizzly Welder H3266 User Manual

MODEL H3266  
ENGINE CLEANING GUN  
INSTRUCTION SHEET  
Siphon  
Knob  
EYE/EAR INJURY HAZARD!  
Wear safety glasses and  
hearing protection when  
using this tool!  
Nozzle  
INJURY HAZARD!  
Always disconnect tool from  
air to prevent unexpected  
operation during service!  
Trigger Knob  
DO NOT EXCEED 90 PSI!  
Personal injury could  
occur.  
Figure 1. Model H3266 (siphon hose not  
EXPLOSION HAZARD!  
Do not spray flammable  
fluids near and open flame  
or ignition source.  
shown).  
4. To adjust the amount of solution being used,  
rotate the siphon knob; to adjust the amount  
of air flow; rotate the trigger knob.  
LUNG HAZARD!  
Always wear a respirator  
when using this tool and  
use in a well ventilated  
area.  
5. Hold the gun so the nozzle is 6–10" from the  
surface and squeeze the trigger knob.  
6. When you are done, place the siphon hose  
into a clean bucket of water and spray until  
the gun sprays clean water.  
Specifications  
Air Inlet Size .............................................14" NPT  
Air Consumption...................................... 12 CFM  
Operating Pressure ................................... 90 PSI  
Wand Length.....................................................9"  
Weight .........................................................11 lbs  
Air Supply  
The engine cleaning gun MUST be regularly lubri-  
cated with 3-4 drops of air tool oil directly into the  
air fitting before each use. For best results, we  
recommend using an in line filter, lubricator, and  
regulator, as shown in Figure 2.  
Operation  
1. Make sure the engine is cool to the touch, and  
disconnect the positive battery cable.  
Quick  
Connector  
Quick  
Connector  
Lubricator  
Regulator  
2. Connect the engine cleaning gun (Figure 1) to  
an air supply set at 60 PSI. Adjust the trigger  
knob until there is no air escaping from the  
cleaning gun.  
Your  
Tool  
Air  
Compressor  
Quick  
Coupler  
Quick  
Coupler  
Air Hose  
Filter  
3. Connect the siphon hose to the cleaning gun  
and place the other end into an approved con-  
tainer of engine cleaning solution.  
Figure 2. Installing your tool.  
 

Graco Crib ISPP020AB User Manual
Grizzly Grinder D2X User Manual
Grizzly Sander G0472 User Manual
Hamilton Beach Iron 22464 User Manual
Harman Kardon Home Theater System HKTS 5 User Manual
Hasbro Games 3 Minute Word Game User Manual
Hasbro Games 45519 User Manual
Hotpoint Range RGB508PEAAD User Manual
Hunter Fan Baby Accessories 24756 User Manual
Image Treadmill IMTL496060 User Manual