HP 2 Port USB 2.0 Cardbus
User’s Manual
Product Number PM453A #ABA
Printed in China
©Copyright 2004 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice
The only warranties for HP products and services are set forth in the express
warranty statements accompanying such products and services. Nothing herein
should be construed as constituting an additional warranty. HP shall not be liable
for technical or editorial errors or omissions contained herein.
Contents
Welcome
Installation
Technical Support
4
5
5
- 3 -
Welcome
Congratulations on the purchase of your new HP 2 Port USB 2.0
Cardbus. This guide will provide you the necessary steps to installing
and maintaining your cardbus.
Package Contents
2 Port USB 2.0 Cardbus
AC Adapter
User’s Manual
Warranty Card
System Requirements
•
Available Cardbus slot
Compatible with Microsoft® Windows® 2000/ XP
- 4 -
Installation
STEP 1 – Turn on your
computer and wait for it to
boot up.
STEP 2 – Carefully insert the
HP 2 Port USB 2.0 Cardbus
into an available Cardbus
slot.
STEP 3 – The appropriate
drivers for your device will
automatically be installed.
Technical Support
For technical assistance call 1-866-314-7239 or visit
Technical Support hours of operation: Monday - Friday 8:30am to
10:00pm E.S.T.
- 5 -
FCC STATEMENT
This device complies with part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction guide, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
•
•
•
•
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult a service representative for help.
Properly shielded and grounded cables and connectors must be used in order to comply with FCC emission limits.
Hewlett-Packard is not responsible for any radio or television interference caused by using other than recommended
cables and connectors or by unauthorized changes or modifications to this equipment. Unauthorized changes or
modifications could void the user’s authority to operate the equipment.
For regulatory compliance information only, contact:
Hardware Quality Eng. Manager
Hewlett-Packard Company - CPC
10500 Ridgeview Court
Cupertino, CA95014
Telephone: 1(408) 343-5000
Tested To Comply With FCC Standards
FOR HOME OR OFFICE USE
This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de classe B est conforme à la
norme NMB-003 du Canada.
|