High Performance
Oscillating Fan
Owner’s Guide
Models
90400
90406
44826-01
20111014
©2011 Hunter Fan Co.
1
WELCOME
UNPACKING
Thank you for choosing the Hunter
Millennium™ Table Fan. This
manual gives you complete
instructions for using your fan.
Here are some the features you
will enjoy with your fan:
As you unpack the fan, save the
carton and packing materials in
case you want to move or ship
the unit in the future.
Carefully remove all items from the
box.
•An attractive design that enhances
NOTE: It is best to have someone
hold the box while you lift
any decor
•A powerful Hunter motor for
maximum air flow
the fan and the protective
packaging out of the carton.
•Three speeds to adjust your
Make sure all shipping materials
are removed from fan before
operating.
comfort level
Before installing your fan, record
the following information for
your records and for warranty
assistance.
Model Name __________________
Date Code ____________________
Date Purchased _______________
Where Purchased ______________
Please attach your
receipt or a copy of
your receipt to this manual
for future reference.
©2011 Hunter Fan Co.
3
44826-01 20111014
GROUNDING INSTRUCTIONS
This appliance is for household
LINE CORD SAFETY TIPS
use only and may be plugged into
any 120-volt AC electrical outlet
(ordinary household current). DO
NOT use any other type of outlet.
1. NEVER pull or yank on the
cord or the appliance.
2. To insert plug, grasp it firmly
and guide it into the outlet.
3. To disconnect the appliance,
grasp the plug and remove it
from the outlet.
WARNING
This unit is suitable for grounded
receptacle use only.
4. Before each use, inspect
the line cord for cuts and/or
abrasion marks. If any are
found, the appliance should
be serviced and the line cord
replaced. Please return it
to our Service Department
or to an authorized service
representative.
The cord has a grounded plug as
shown in Figure 1. An adapter, as
shown in Figure 2, is available for
connecting three-blade grounding-
type plugs to two-slot receptacles.
The green grounding lug extending
from the adapter must be
connected to a permanent ground
such as a property grounded
outlet box. The adapter should not
be used if a three-slot grounded
receptacle is available.
5. NEVER wrap the cord tightly
around the appliance, as this
could place undue stress on
the cord where it enters the
appliance and could cause it
to fray and break.
6. DO NOT operate appliance
if the line cord shows any
damage, if the appliance
works intermittently or stops
working entirely.
Grounded
Plug
Adapter
Metal
Screw
Grounding
Means
Grounded Outlet
Box Cover
Grounding
Pin
Grounded Outlet
Box Cover
FIGURE 1
FIGURE 2
©2011 Hunter Fan Co.
4
44826-01 20111014
FUSED PLUG
This plug is a safety feature. It contains
a safety device (fuse) that should
not be removed. Discard product if
the attachment plug is damaged. To
reduce the risk of fire, electric shock
and personal injury, DO NOT remove,
replace, repair or tamper with the
originally supplied plug. If the fan does
not function properly, it may be due to the
safety device incorporated in this plug.
If the fuse fails, it is generally due
to a short circuit or circuit overload.
Replace the fuse as per the instructions
below. If the replacement fuse
Figure 1
Figure 2
Figure 3
fails, immediately unplug the unit
and contact our technical support
department for assistance.
Fuse Replacement:
1. To replace the fuse, first turn the
unit it off and unplug it from the wall.
Locate the door on top of the plug.
Figure 1.
2. Slide the door on top of the plug
towards the blades. Figure 2.
3. Carefully remove the fuse from
the clips holding it on the top and
bottom. Figure 3.
Warning! Electrical Hazard! Only
replace with a fuse type and rating
matching what was removed from the
product.
4. Gently push the fuse back into the
pins that will hold it in place.
Note: If the fuse is not seated properly,
the unit will not function.
5. Slide the door back over the fuse
box in the plug.
6. Plug the fan back in and resume
use.
©2011 Hunter Fan Co.
5
44826-01 20111014
OPERATION
This appliance is for household use
only.
4. To select the speed, turn the
Power/Speed Control knob
from OFF to the desired speed
setting: O (off), III (High), II
(Medium), I (Low).
1. Place the fan on a dry, safe, flat
surface where it cannot fall or
be pulled by the cord.
5. To control the upward and
downward direction of airflow,
loosen the screw on the side of
the fan housing neck. Adjust to
the desired angle and tighten
the screw.
2. Plug the fan into a grounded
120-volt AC electrical outlet
(ordinary household current).
DO NOT use any other type of
outlet. Make sure that the rated
voltage of the fan is the same
as the power source before
plugging it into the power
source.
6. To make the fan oscillate,
push the oscillation knob
down. To stop oscillating, pull
the oscillation knob up. The
oscillation knob is located on
the top of the fan housing, near
the handle.
3. Turn the fan “ON” or “OFF”
by turning the Power/Speed
Control knob. The power
should always be OFF before
unplugging the fan.
Handle
Oscillation Knob
Motor Housing
Up/Down
Adjustment Screw
Power/Speed
Control Knob
Base
FIGURE 3
©2011 Hunter Fan Co.
6
44826-01 20111014
MAINTENANCE
This fan is permanently lubricated
and will not require additional
lubrication (oil) for the life of
the fan.
4. Use a dry or slightly damp lint
freecloth to clean the fan.
5. Use a soft, slightly damp cloth
to wipe the remaining fan parts.
This fan requires little maintenance
and contains no user
6. DO NOT allow water or any
other liquid to get into the motor
housing or base.
serviceable parts. DO NOT
try to fix it yourself. Contact
qualified service personnel
if servicing is needed.
7. Reassemble the fan after
blades and grills have dried
completely. Align the grills,
replace the ring, and replace
the screw.
TO CLEAN:
1. Before cleaning, turn fan off
and unplug from electrical
outlet. Wipe off excess dust
with a lint free cloth.
8. DO NOT plug fan into an
electrical outlet until it has been
fully reassembled.
2. To ensure adequate air
circulation to the motor, keep
vents located at the rear of
the motor housing free from
dust accumulation. A vacuum
cleaner hose can be used to
clean these vents.
Front
Grill
Back
Grill
3. DO NOT immerse the fan in
water or any other liquid.
Handle
CLEANING GRILL AND BLADE:
Blade
Screw
Oscilation
Knob
1. Turn the fan off and unplug
from the electrical outlet.
2. Disassemble grills by carefully
removing the screw on the
bottom of the ring. See Figure 4.
3. Remove the ring.
Motor
Housing
Up/Down
Adjustment
Screw
Ring
Power/Speed
Control Switch
Base
FIGURE 4
©2011 Hunter Fan Co.
7
44826-01 20111014
STORAGE
TROUBLESHOOTING
1. Disassemble and clean fan
before storing.
PROBLEM
•Fan will not oscillate.
SOLUTION
2. Keep the original packaging for
the purpose of storing the fan.
•Push down on knob on top of
motor housing to activate
oscillation.
3. ALWAYS store the fan in a dry
place.
4. NEVER store the fan while it is
still plugged in.
PROBLEM
•Can not adjust the
5. NEVER wrap the cord tightly
around the fan.
angle of the fan.
SOLUTION
6. DO NOT put any stress on the
cord where it enters the fan, as
it could cause the cord to break.
•Loosen the screw on the side of
the fan neck. Adjust to the
desired angle and tighten the
screw.
If you have tried these
troubleshooting solutions and still
have trouble, call 1-888-830-1326
(For CAN: 1-866-268-1936) or visit our
©2011 Hunter Fan Co.
8
44826-01 20111014
WARRANTY
The Hunter Fan Company makes the OR FITNESS FOR A PARTICULAR
following limited warranty to the user PURPOSE, ARE VOIDED. NO
or consumer purchaser of this Hunter WARRANTY,
Portable fan: IMPLIED,
EXPRESSED
INCLUDING
OR
ANY
WARRANTY OF MERCHANTABILITY
If your Hunter Portable Fan motor OR FITNESS FOR A PARTICULAR
fails at any time within five years after PURPOSE, IS MADE IN RESPECT
the date of sale to you due to a defect TO THE GLASS GLOBES OR LIGHT
in material or workmanship, labor BULBS OR THE FINISH ON ANY
to repair the defect will be provided METAL PORTION OF THE FAN.
free of charge at our nearest service THIS WARRANTY IS IN LIEU OF ALL
center or our Service Department OTHER EXPRESS WARRANTIES. THE
in Memphis, Tennessee. You will DURATION
be responsible for labor costs after OF ANY IMPLIED WARRANTY,
this one-year period. The foregoing INCLUDING, BUT NOT LIMITED
limited warranty applies only to the TO ANY IMPLIED WARRANTY OF
motor itself, and does not apply to MERCHANTABILITY OR FITNESS
electronic controls such as remote FOR A PARTICULAR PURPOSE, IN
controls, remote control receivers or RESPECT TO ANY HUNTER FAN
transmitters used in conjunction with MOTOR OR OTHER FAN PART, IS
the motor. These electronic control EXPRESSLY LIMITED TO THE PERIOD
items are included in the one year OF THE EXPRESS WARRANTY SET
limited warranty below.
FORTH ABOVE FOR SUCH MOTORS
AND OTHER PARTS.
If any part of your Hunter Portable
Fan other than the motor fails at any This warranty is voided if your Hunter
time with one year after the date of Fan is not purchased and used in the
sale to you due to a defect in material USA.
or workmanship, we will repair or, at
our option, replace the defective part This warranty excludes and does
free of charge for parts and labor not cover defects, malfunctions or
performed at our nearest service failures of any Hunter Portable
center or at our Service Department fan which were caused by repairs
in Memphis, Tennessee.
by persons not authorized by us,
use of parts or accessories not
IF THE USER OR CONSUMER authorized by us, mishandling,
PURCHASER CEASES TO OWN THE improper installation, modifications,
FAN, THIS WARRANTY AND ANY or damage to the Hunter Portable
IMPLIED WARRANTY WHICH THEN fan while in your possession, or
REMAINS IN EFFECT, INCLUDING unreasonable use, including failure
BUT NOT LIMITED TO ANY IMPLIED to provide reasonable and necessary
WARRANTY OF MERCHANTABILITY maintenance.
©2011 Hunter Fan Co.
9
44826-01 20111014
To obtain servicing, contact the IN NO EVENT SHALL HUNTER
nearest Hunter authorized service FAN COMPANY BE LIABLE FOR
center or the Hunter Fan Company CONSEQUENTIAL OR INCIDENTAL
Service Department, 7130 Goodlett DAMAGES.
Farms Pkwy. Suite 400, Memphis,
Tennessee 38016. Please contact us SOME STATES DO NOT ALLOW
before shipping your fan to us. If we LIMITATIONS ON HOW LONG AN
authorize you to ship it to us, you IMPLIED WARRANTY LASTS OR THE
will be responsible for all insurance EXCLUSION OR LIMITATION OF
and freight or other transportation INCIDENTAL OR CONSEQUENTIAL
charges to our factory service center. DAMAGES
SO
THE
ABOVE
We will return your Hunter Fan LIMITATION MAY NOT APPLY TO
freight prepaid. Your portable fan YOU.
should be properly packed to avoid
damage in transit since we will not THE WARRANTY GIVES YOU
be responsible for any such damage. SPECIFIC LEGAL RIGHTS AND YOU
Proof of purchase is required when MAY ALSO HAVE OTHER RIGHTS
requesting warranty service. The WHICH VARY FROM STATE TO
purchaser must present sales receipt STATE.
or other document that establishes
proof of purchase.
©2011 Hunter Fan Co.
10
44826-01 20111014
|