ClassicTable Fan
Oscillating Fan
Owner’sManual
Models
90401
90402
44832-01
20130103
©2013 Hunter Fan Co.
WELCOME
UNPACKING
Thank you for choosing the Hunter
Classic Table Fan. This manual gives
you complete instructions for using
your fan. Here are some the features
you will enjoy with your fan:
As you unpack the fan, save the carton
and packing materials in case you want
to move or ship the unit in the future.
Carefully remove all items from the box.
Make sure all shipping materials are
removed from fan before operating.
• An attractive design that
enhances any decor
• A powerful Hunter motor for
maximum air flow
• Three speeds to adjust your
comfort level
Before using your fan, record the
following information for your records
and for warranty assistance.
Model Name _________________
Date Purchased ______________
Where Purchased _____________
Please attach your
receipt or a copy of
your receipt to this manual
for future reference.
3
GROUNDING INSTRUCTIONS
This appliance is for household
LINE CORD SAFETY TIPS
use only and may be plugged into
any 120-volt AC electrical outlet
(ordinary household current). DO
NOT use any other type of outlet.
1. NEVER pull or yank on the
cord or the appliance.
2. To insert plug, grasp it firmly
and guide it into the outlet.
3. To disconnect the appliance,
grasp the plug and remove it
from the outlet.
WARNING
This unit is suitable for grounded
receptacle use only.
4. Before each use, inspect
the line cord for cuts and/or
abrasion marks. If any are
found, the appliance should
be serviced and the line cord
replaced. Please return it
to our Service Department
or to an authorized service
representative.
The cord has a grounded plug as
shown in Figure 1. An adapter,
(not included) as shown in Figure
2, is available for connecting
three-blade grounding-type
plugs to two-slot receptacles.
The green grounding lug
extending from the adapter must
be connected to a permanent
ground such as a property
5. NEVER wrap the cord tightly
around the appliance, as this
could place undue stress on
the cord where it enters the
appliance and could cause it
to fray and break.
grounded outlet box. The adapter
should not be used if a three-slot
grounded receptacle is available.
6. DO NOT operate appliance
if the line cord shows any
damage, if the appliance
works intermittently or stops
working entirely.
Grounded
Plug
Adapter
Metal
Screw
Grounding
Means
Grounded Outlet
Box Cover
Grounding
Pin
Grounded Outlet
Box Cover
FIGURE 1
FIGURE 2
4
FUSED PLUG
This plug has a safety feature. It
contains a safety device (fuse) that
should not be removed. Discard
product if the attachment plug is
damaged. To reduce the risk of fire,
electric shock and personal injury,
DO NOT remove, replace, repair or
tamper with the originally supplied
plug. If the Fan does not function
properly, it may be due to the safety
device incorporated in this plug.
If the fuse fails, it is generally
Figure 3
Figure 4
Figure 5
due to a short circuit or circuit
overload. Replace the fuse as
per the instructions below. If the
replacement fuse fails, immediately
unplug the unit and contact our
technical support department for
assistance.
Fuse Replacement:
1. To replace the fuse, first turn the
unit it off and unplug it from the
wall. Locate the door on top of
the plug. Figure 1.
2. Slide the door on top of the plug
towards the blades. Figure 2.
3. Carefully remove the fuse from
the clips holding it on the top and
bottom. Figure 3.
WARNING
Electrical Hazard! Only replace with
a fuse type and rating matching what
was removed from the product.
4. Gently push the fuse back into
the pins that will hold it in place.
Note: If the fuse is not seated properly,
the unit will not function.
5. Slide the Door back over the fuse
box in the plug.
6. Plug the fan back in and
resume use.
5
OPERATION
4. To select the speed, move the
power/speed lever from OFF to
the desired speed setting: O (off),
I (low), II (medium), III (high).
This appliance is for household use only.
1. Place the fan on a dry, safe, flat
surface where it cannot fall or
be pulled by the cord.
5. To make the fan oscillate, push
the oscillation knob down. To stop
oscillating, pull the oscillation
knob up. The oscillation knob
is located on the top of the fan
housing, near the handle.
2. Plug the fan into a grounded
120-volt AC electrical outlet
(ordinary household current).
DO NOT use any other type of
outlet. Make sure that the rated
voltage of the fan is the same
as the power source before
plugging it into the power
source.
3. Turn the fan “ON” or “OFF” by
moving the power/speed lever.
The power should always be
OFF before unplugging the fan.
Handle
Oscillation Knob
Motor Housing
Power/Speed
Lever
Base
FIGURE 6
6
MAINTENANCE
This fan is permanently lubricated and
will not require additional lubrication (oil)
for the life of the fan.
CLEANING GRILL AND BLADE:
1. Turn the fan off and unplug
from the electrical outlet.
This fan requires little maintenance
and contains no user serviceable parts.
DO NOT try to fix it yourself. Contact
qualified service personnel
2. Disassemble grills by carefully
removing the screw on the
bottom of the ring. See Figure 4.
3. Remove the ring.
if servicing is needed.
4. Use a dry or slightly damp lint
free cloth to clean the fan.
TO CLEAN:
1. Before cleaning, turn fan off
and unplug from electrical
outlet. Wipe off excess dust
with a lint-free cloth.
5. Use a soft, slightly damp cloth
to wipe the remaining fan parts.
6. DO NOT allow water or any
other liquid to get into the motor
housing or base.
2. To ensure adequate air
circulation to the motor, keep
vents located at the rear of
the motor housing free from
dust accumulation. A vacuum
cleaner hose can be used to
clean these vents.
7. Reassemble the fan after
blades and grills have dried
completely. Align the grills,
replace the ring, and replace
the screw.
8. DO NOT plug fan into an
electrical outlet until it has been
fully reassembled.
3. DO NOT immerse the fan in
water or any other liquid.
Front
Grill
Back
Grill
Handle
Blade
Screw
Oscillation
Knob
Motor Housing
Power/Speed Lever
Ring
Base
FIGURE 7
7
STORAGE
TROUBLESHOOTING
1. Disassemble and clean fan
before storing.
PROBLEM
• Fan will not oscillate.
SOLUTION
2. Keep the original packaging for
the purpose of storing the fan.
• Push down on knob on top of motor
3. ALWAYS store the fan in a
dry place.
housing to activate oscillation.
If you have tried these troubleshooting
solutions and still have trouble, call
1-888-830-1326 (For CAN: 1-866-
268-1936) or visit our Web site at
4. NEVER store the fan while it is
still plugged in.
5. NEVER wrap the cord tightly
around the fan.
6. DO NOT put any stress on the
cord where it enters the fan, as
it could cause the cord to break.
8
WARRANTY
The Hunter Fan Company makes the PURPOSE, ARE VOIDED. NO
following limited warranty to the user WARRANTY,EXPRESSEDORIMPLIED,
or consumer purchaser of this Hunter INCLUDING ANY WARRANTY OF
Portable fan:
MERCHANTABILITY OR FITNESS FOR
A PARTICULAR PURPOSE, IS MADE
If your Hunter Portable Fan motor IN RESPECT TO THE GLASS GLOBES
fails at any time within one year after OR LIGHT BULBS OR THE FINISH
the date of sale to you due to a defect ON ANY METAL PORTION OF THE
in material or workmanship, labor FAN. THIS WARRANTY IS IN LIEU OF
to repair the defect will be provided ALL OTHER EXPRESS WARRANTIES.
free of charge at our nearest service THE DURATION OF ANY IMPLIED
center or our Service Department WARRANTY,
INCLUDING,
BUT
in Memphis, Tennessee. You will NOT LIMITED TO ANY IMPLIED
be responsible for labor costs after WARRANTY OF MERCHANTABILITY
this one-year period. The foregoing OR FITNESS FOR A PARTICULAR
limited warranty applies only to the PURPOSE, IN RESPECT TO ANY
motor itself, and does not apply to HUNTER FAN MOTOR OR OTHER
electronic controls such as remote FAN PART, IS EXPRESSLY LIMITED
controls, remote control receivers or TO THE PERIOD OF THE EXPRESS
transmitters used in conjunction with WARRANTY SET FORTH ABOVE FOR
the motor. These electronic control SUCH MOTORS AND OTHER PARTS.
items are included in the one year
limited warranty below.
This warranty is voided if your
Hunter Fan is not purchased and
If any part of your Hunter Portable used in the USA.
Fan other than the motor fails at any
time with one year after the date of This warranty excludes and does
sale to you due to a defect in material not cover defects, malfunctions or
or workmanship, we will repair or, at failures of any Hunter Portable fan
our option, replace the defective part which were caused by repairs by
free of charge for parts and labor persons not authorized by us, use of
performed at our nearest service parts or accessories not authorized
center or at our Service Department by us, mishandling, improper
in Memphis, Tennessee.
installation,
damage to the Hunter Portable
modifications,
or
IF THE USER OR CONSUMER fan while in your possession,
PURCHASER CEASES TO OWN THE or unreasonable use, including
FAN, THIS WARRANTY AND ANY failure to provide reasonable and
IMPLIED WARRANTY WHICH THEN necessary maintenance.
REMAINS IN EFFECT, INCLUDING
BUT NOT LIMITED TO ANY IMPLIED To obtain servicing, contact the
WARRANTY OF MERCHANTABILITY nearest Hunter authorized service
OR FITNESS FOR A PARTICULAR center or the Hunter Fan Company
9
Service Department, 7130 Goodlett
Farms Pkwy. Suite 400, Memphis,
Tennessee 38016. Please contact us
before shipping your fan to us. If we
authorize you to ship it to us, you
will be responsible for all insurance
and freight or other transportation
charges to our factory service
center. We will return your Hunter
Fan freight prepaid. Your portable
fan should be properly packed
to avoid damage in transit since
we will not be responsible for any
such damage. Proof of purchase is
required when requesting warranty
service. The purchaser must present
sales receipt or other document that
establishes proof of purchase.
IN NO EVENT SHALL HUNTER
FAN COMPANY BE LIABLE
FOR
CONSEQUENTIAL
OR
INCIDENTAL DAMAGES.
SOME STATES DO NOT ALLOW
LIMITATIONS ON HOW LONG
AN
IMPLIED
WARRANTY
LASTS OR THE EXCLUSION OR
LIMITATION OF INCIDENTAL OR
CONSEQUENTIAL
DAMAGES
SO THE ABOVE LIMITATION MAY
NOT APPLY TO YOU.
THE WARRANTY GIVES YOU
SPECIFIC LEGAL RIGHTS AND
YOU MAY ALSO HAVE OTHER
RIGHTS WHICH VARY FROM
STATE TO STATE.
Company
7130 Goodlett Farms Pkwy., Suite 400
Memphis, Tennessee 38016
Impreso en China y Taiwán
10
|