IKELITE VIDEO CASE
P R E P A R A T I O N
SUPPLEMENTAL INSTRUCTIONS FOR
PACKAGED WITH HOUSING__________________________________________________
#6080 Canon HG-10
• External UR/Pro Color Filter
• Internal Lens Shade
• Silicone Lubricant
COLOR FILTER_____________________________________
The installation and usage of the external UR/Pro
color filter is described in the general instruction manual.
LENS SHADE_______________________________________
The internal lens shade helps block light reflection/
refraction caused by the interaction of the external color
External
Color Filter
Internal
Lens Shade
filter and the port.
Carefully thread the lens shade on the front of the
DO NOT
camera lens. The lens threads are very fine;
cross thread. It should screw on
very easily. If it is difficult to turn, you are cross threading.
Completely thread the lens shade into the camera to avoid any potential
clearance or sealing problems when the camera is installed and the housing is sealed.
SUPER-EYE VIEWFINDER_____________________________________________________
See exactly what the camera sees underwater using the camera's electronic
viewfinder in conjunction with the Ikelite Super-Eye, which is permanently mounted
in the eyeport on the clear back plate. The Super-Eye extends the viewfinder image
to provide enhanced viewing underwater.
This supplemental set of instructions describes additional features specific
to your housing model. Prior to testing the system in the water, please read this
supplement along with the general instruction manual to become familiar with
its features and functions.
Ikelite Video Cases are slightly negative
Quick Start / Disp.
in salt water for stability. This housing has
been water pressure tested at the factory
and has a working depth of 60m (200').
Power
LCD MONITOR / EXTERNAL MIRROR_________________________________________
The camera's LCD monitor can be viewed from the rear of the housing, using the
external mirror featured on the side of the housing.
Open the LCD monitor on the camera, rotate 180°, and then press it back against
the side of the camera. The external mirror is hinged so that it can be opened to reflect
the image from the camera's LCD monitor for viewing from the rear of the housing. The
LCD image will appear opposite, left to right.
Lid Snap
Auto / P-Mode
Port
HOUSING CONTROLS__________________
• Power On/Off / Mode
• Start/Stop
Eyeport
Mirror
Joy Stick #2/
Function
• Power Zoom
• Photo Button
• Auto / Manual Focus Lock
• Control Dial
During transportation, please remember to close the mirror by pressing it against
the side of the housing.
Bottom Bar
Base
Joy Stick #1
Control Dial
BATTERY AND TAPE__________________________________________________________
Install a fully charged Sony battery on the camera:
• Type / Card Switch
• Auto / P-Mode
Photo
Button
Canon NB-2LH, BP-2L13, BP-2L14, BP-2L 24H
Other brand batteries may not fit inside the housing.
Make sure you have loaded an appropriate digital cassette tape in the camera.
• Joy Stick #1
• Joy Stick #2 / Function
• Quick Start / Disp.
Zoom
Tape/
Card
Rec./
S.S.
MAIN O-RING #0109________________
O-rings last several years if properly
maintained. Control seals should not need
to be replaced as long as the control shafts
are kept clean and lightly lubricated.
|