FILTER REPLACEMENT INSTRUCTIONS - 4000,5000,6000 & 8000 SERIES
REPLACE THE PRE-FILTER
These replacement filters will
extend the life of your AllerAir
unit. Please be sure to follow
the instructions for changing
the filters in your unit.
We recommend changing pre-
STEP 1
STEP 2
STEP 3
filters every two months, HEPA
filters every three to five years,
and carbon filters every two
years.
Make sure the unit is
set to "off" and the
unit is unplugged.
Lay the unit on its side.
Slowly remove the dirty filter
to avoid dispersing its contents.
Gently insert it into a plastic bag
before discarding.
Insert the new filter by
pressing it gently against
the sides of the carbon
filter inside the unit
REPLACE CARBON & HEPA FILTERS
STEP 1
STEP 2
STEP 3
STEP 4
Make sure the unit is
set to "off" and the
unit is unplugged.
Using a #2 Philips screwdriver,
remove the four screws that
hold the base onto the unit.
Grasp the wheels. Remove
the base by pulling gently
on the wheels
Reach inside the unit, and
remove the felt pad.
Lay the unit upside down,
so that the wheels face up.
NEW
CARBON
NEW
HEPA
STEP 6
STEP 7
STEP 8
STEP 5
Then, remove the HEPA filter
with the same technique.
Now, gently insert the new
HEPA filter.
Then, insert the new
carbon filter into the unit.
First, remove the carbon
filter. (pull up gently by
placing thumbs on the
inner side of the filter)
Step 10
Step 11
Replace the four screws.
Step 12
Turn the unit back onto its
Step 9
Put back the felt pad
removed in STEP 4.
Replace the base, making sure the
arrow on the gold sticker lines up
with unit's rear seam.
wheels. It is now ready for use.
|