Chicago Electric Work Light 93904 User Manual

ITEM 93904  
HOLOGENVEHICLEWORKLIGHT  
Bulb Replacement Procedure:  
1. To replace the Halogen Vehicle Worklight Bulb you must first remove  
the glass lens in front of it. First remove the worklight from the vehicle,  
place it on the ground with a soft cloth or rag under it.  
2. The glass Lens is held in by the rubber lip of the light housing. To  
remove it peel back the rubber lip of the Worklight then pull out the glass  
lens. CAUTION: The glass lens is difficult to remove. If you are not com-  
fortable doing this it should be done by a qualified service technician.  
3. Once the lens is out remove the H3 bulb and replace it. You will not need  
any tools to remove and replace the bulb.The bulb has two wires on it that  
are held in by a clip. Pull the bulb straight out to remove it then insert the  
new bulb by pressing it into the clip.  
4. The final step is to reinsert the glass lens by firmly pressing it back into  
the worklight housing.  
1. Always wear ANSI approved safety goggles and gloves when working  
with tools and equipment. 2. Replace the bulb at your own risk!  
3. DO NOT use a screwdriver or any metal object to pry the glass lens out!  
Doing so could break, crack or shatter the glass lens.  
 
01/06  
SAVE THESE WARNINGS.  
Made in India  
 

Black Box Network Router ME444A 530 R3 User Manual
Black Box Patio Umbrella 24 and 48 Port Category 6A Staggered Patch Panels User Manual
Bogen Speaker S86T725PG8WBR User Manual
Braun Electric Shaver 5325 User Manual
Brother Electronic Accessory PE DESIGN 7 User Manual
Cabletron Systems Network Router 9032578 05 User Manual
CDA Oven 6Q6 User Manual
Char Broil Charcoal Grill 10501572 User Manual
Chief Manufacturing Indoor Furnishings PSH 2000 User Manual
Chromalox Electric Heater ICH 18025 User Manual