Coleman Tent 2000001643 User Manual

TM  
LEGACY TENT  
MODEL 2000001643  
Fig. 2  
Before you begin  
Read all instructions before set up.  
• Select a level site clear of rocks, branches, and other hard or sharp  
objects, to install your tent.  
WARNING: Keep clear of overhead power lines.  
• Do not set up your tent under trees because of potential lightning  
strikes or falling tree limbs in inclement weather.  
• Secure with all stakes and guylines provided to prevent property  
damage or personal injury.  
Door  
• For best results in windy conditions, position narrow end of tent into  
the wind.  
• Enlist the help of at least one other person to assist you when it is  
time to assemble the tent.  
2A  
2B  
Pole Descriptions  
Pole  
Pole  
Pole  
2C  
Description  
Qty. Dia.  
Repair Kit Replacement Kit  
Main Body Pole, black  
Side Body Pole, grey  
Rainfly Pole, black  
Vertical Door Pole, black,  
short w/rubber tips  
2
2
1
11mm 501000539  
9.5mm 501000540  
11mm 501000539  
6.3mm 501000543  
6.3mm 501000543  
501000549  
501000548  
501000549  
Hinged, Rigid Door  
1. Assemble Vertical Door Pole (shorter black pole with plastic tips);  
then insert through zippered vertical pole sleeve on hinged side of  
door. (Fig. 3)  
2. Insert end of Vertical Door Pole into bottom hinge plate, apply  
pressure to form a slight bow, then insert other tip of pole into top  
hinge. Zip up vertical pole sleeve. (Fig. 4 & 5)  
3. Assemble Door Pole (longer black pole with plastic cap tips); then  
insert into zippered pole sleeve at top of door. (Fig. 6)  
4. Insert end of Door Pole into top hinge plate, apply pressure to form  
a bow, then insert other tip of pole into the bottom hinge. (Fig. 7)  
5. Zip up pole sleeve to enclose Door Pole. (Fig. 8)  
1
1
501000545  
501000545  
Door Pole, black,  
long w/rubber tips  
To Set Up Tent  
1. Unfold tent and spread out on a clean, level surface with the  
door facing the desired direction. (Fig. 1)  
2. Assemble all poles by interlocking the shock-corded, sections  
together.  
Fig. 3  
Fig. 4  
Fig. 5  
Vertical Pole  
Sleeve  
3. Insert grey Side Body Poles through the grey trimmed sleeves  
on both sides of tent; then insert black Main Body Poles  
through black trimmed sleeves, in center of tent, forming a  
“X”. Make sure black Main Body Poles overlap the grey Side  
Body Poles. (Fig. 1)  
Door Hinge  
Fig. 7  
Fig. 6  
Sleeves with Black Trim  
Fig. 1  
Sleeve with  
Grey Trim  
Top  
Door  
Hinge  
Sleeve with  
Grey Trim  
Pole  
Sleeve  
Fig. 8  
Door  
To Attach Rainfly  
1. Insert black Rainfly Pole with through sleeve in underside of  
Front of Tent  
Rainfly. (Fig. 9)  
Black, Shock-corded Main Body Poles  
2. Drape Rainfly over tent with Rainfly Pole centered above front door  
& the dark blue vestibule flaps located in the front. (Fig 9)  
Grey, Shock-corded Side Body Poles  
Fig. 9  
4. Insert end of each black Main Body Poles & grey Side Body  
Poles into pins. (Fig. 2 & 2A)  
Rainfly Sleeve  
5. Go to opposite end of each pole and gradually apply pressure  
to each forming arches. Insert the pin into each pole end at the  
sides and corners of tent. (Fig. 2 & 2A)  
6. Attach frame clips along edges of tent to the black Main Body  
Poles & grey Side Body Poles. (Fig. 2B)  
Rainfly  
Black Rainfly  
Pole  
7. Stretch tent until taut, then secure metal loops located on both  
sides and web loops located at four corners of tent with  
stakes. (Fig. 2C)  
Door  
(continued on other side)  
 

CompuSTAR Automobile Alarm 2000R User Manual
Cooper Lighting Indoor Furnishings CFS User Manual
Cypress Computer Hardware CY7C68033 User Manual
Delta Electronics Power Supply PMC 24V050W1AA User Manual
Dymo Label Maker 450 User Manual
Easyrig Camcorder Accessories Camcorder Tripod User Manual
Electro Voice Speaker DL15W User Manual
Estate Range W10173755D User Manual
Extron electronic TV Cables DSC 3G HD A User Manual
Frigidaire Cooktop CFEF3048LS User Manual