EverFocus Home Security System Eq250 User Manual

EVERFOCUS  
1/3” Sony CCD Aluminum Box Housing  
Color Camera  
Operation Instructions  
Model No. EQ350/EQ250  
Please read this manual first for correct installation and operation. This manual should be retained  
for future reference. The information in this manual was current when published. The  
manufacturer reserves the right to revise and improve its products. All specifications are therefore  
subject to change without notice.  
PRECAUTIONS  
1. Do not install the camera near electric or magnetic fields.  
Install the camera away from TV, radio transmitter, magnet, electric motor, transformer,  
audio speakers since the magnetic fields generate from above devices will distort the video  
images.  
2. Never disassemble the camera nor put impurities in it.  
Disassembly or impurities may result in trouble or fire.  
3. Never face the camera toward the sun.  
Direct sunlight or severe ray may cause fatal damage to sensor and internal circuit.  
4. Keep the power cord away from water and liquid.  
Touching the wet power cord may result in electric shock.  
5. Never install the camera in areas exposed to water, oil or gas.  
Water, oil or gas may result in failure, electric shock or fire.  
6. Cleaning  
Do not touch the surface of sensor by hand directly. Use a soft cloth to remove the dirt from  
the camera body. Use lens tissue or a cotton swab and ethanol to clean the sensor and the  
camera lens.  
 
SPECIFICATIONS  
Type  
EQ350  
EQ250  
Pickup Device  
1/3'' SONY Super HAD CCD  
NTSC: 768(H) x 494(V)  
PAL: 752(H) x 582(V)  
NTSC or PAL  
NTSC: 510(H) x 492(V)  
PAL: 500(H) x 582(V)  
Picture Elements  
Video Format  
NTSC: 525 TV lines, 60 fields/sec  
PAL: 625 TV lines, 50 fields/sec  
Scanning System  
Horizontal Resolution  
Sensitivity  
560TVL  
380TVL  
0.3Lux/F=1.2  
0.5Lux/F=1.2  
S/N Ratio  
Over 48dB(AGC off)  
1/50(1/60)~1/100,000  
C/CS mount  
Electronic Shutter  
Lens Type  
Video Drive / Direct Drive  
ON/OFF Switch  
ON/OFF Switch  
ON/OFF Switch  
Yes  
Back Light Comp.  
Auto Gain Control  
Fluorescent Light  
Auto White Balance  
Gamma Correction  
Video Output  
0.45  
BNC 1.0Vp-p , 75ohm  
Line Lock/Internal Sync  
2 types:  
Sync. Mode  
Power Source  
100VAC~240VAC  
12VDC/24VAC  
100VAC~240VAC 12W max  
24VAC 7W max  
12VDC 4.5W max  
Power Consumption  
Dimensions  
57(W) X 51(H) X 140.2(D) mm;  
2.25"(W) X 2"(H) X 5.52"(D)  
0.5kg ; 1.1lbs  
Weight  
Operating Temperature  
Certification  
-10°C~50°C ; 14°F~122°F (20%~80% Humidity)  
FCC,CE  
2
 
DIMENSIONS  
3
 
HARDWARE OVERVIEW  
1
2
Front  
Side  
3
6
4
Side  
5
7
8
Back  
9
10  
11  
Pigtail Power Model without Audio  
Dual Power Model without Audio  
9
9
11  
10  
Pigtail Power Model with Audio  
Dual Power Model with Audio  
4
 
1. C/CS mount Focus Switch Ring  
Use this ring to adjust the appropriate focal length according to the type of lens. Rotate the  
ring clockwise for the CS-mount lens, rotate it counterclockwise for the C-mount lens. The  
factory setting is CS-mount.  
2. Lens Mount  
To mount an appropriate C-mount or CS-mount lens.  
3. Locking Screw  
Use the locking screw to fix the focal length for preventing losing focus.  
4. DC Lens Connector (4 pin socket)  
To connect to the lens plug of the auto iris lens.  
5. Camera Setting DIP Switches  
There are 6 DIP switches located on the sideboard, which are for camera setting. The  
switches in order from top is Flickerless, Back Light Compensation, Electronic Shutter,  
Automatic Gain Control, Line-Lock and Auto Iris Lens type. Please see camera DIP  
switch setting section.  
6. IRIS Level Control  
Brightness Level can be adjusted from the IRIS level VR while using the direct drive lens.  
Turn counterclockwise to L to get darker picture.  
Turn clockwise to H to get brighter picture.  
7. V-Phase Adjustment Screw  
The vertical phase may require adjustment to synchronize the vertical phase of the camera  
with other camera in the system when it is being used in the line-lock sync mode. Make the  
adjustment when the vertical phase of the camera does not match with other cameras.  
5
 
8. Mounting Base and Fixing Screws  
The mounting base can be attached to either the top or the bottom of the camera, fix the  
mounting base onto the camera by using the 4 fixing screws in the accessory pack.  
9. Video Output Connector  
BNC VBS 1.0 Vp-p, 75ohm  
10. Power Cable (EQ series)  
Power cable varies in different model  
11. Power Pigtail Cable / Power Terminal Pin (EQ series ”A”)  
It varies in different models.  
12. Audio Output (optional)  
It varies in different models, RCA connector  
6
 
INSTALLATION  
1. Remove the lens cover cap.  
2. If a C-mount lens is used, please make sure to turn the C-mount/CS-mount focus switch ring  
at C position before fixing the lens. The default is CS mount.  
3. Screw the lens firmly onto the lens mount. Insert the lens plug into the DC lens connector if  
the auto iris lens is used.  
4. Tighten the focus locking screw.  
5. Connect the video output of the camera to a color monitor or other video device through a 75  
ohm type coaxial cable with BNC female connector.  
6. Connect the Power.  
7. Once the image appears on the monitor, adjust the focus and diaphragm of the lens to obtain  
the best picture.  
8. If the subject is not in focus when adjusting focus of lens, turn the C-mount/CS-mount focus  
switch ring to do focal length adjustment as following:  
i. Loosen the locking screw of the focal length adjustment ring.  
ii. Take picture of subject at a distance more than 20m away from the camera.  
iii. Rotate the focal length adjustment ring to bring the subject in focus.  
iv. Tighten the locking screw while the adjustment is completed.  
7
 
Camera Setting DIP Switch  
Fluorescent ON/OFF  
This is a compensation function for against the images flicker fiercely during fluorescent light  
condition. Shooting the images in fluorescent light by using turn on the Fluorescent function,  
the default setting is Off.  
BLC (Back Light Compensation) ON/OFF  
When BLC is turned on, the AGC, ES and IRIS operating point is determined by averaging over  
the center area instead of entire field-of-view, so that a dimly-lit foreground object at center area  
can be clearly distinguished from brightly-lit backgrounds.  
BLC should not be used unless it is needed to compensate for back-lit. The default setting is OFF.  
ES (Electronic Shutter) OFF/ON  
ES ON: The camera continuously adjusts the shutter speed from 1/60 (NTSC), 1/50 (PAL) second  
to 1/100,000 second according to the luminance conditions of the scene.  
ES OFF: The shutter speed is fixed at 1/60 (NTSC), 1/50 (PAL) second.  
Set ES OFF, when auto iris lens is used or flicker is observed under a very bright fluorescent lamp.  
Otherwise, turn ES on for optimum performance. The default setting is ON.  
AGC (Automatic Gain Control) OFF/ON  
AGC ON: The sensitivity increases automatically when light is low.  
AGC OFF: A-low-noise picture is obtained under a low light condition.  
The default setting is ON.  
LL (Line-Lock) OFF/ON  
To select the sync mode between Internal Sync.(LL off) and Line-Lock (LL on).  
Set the line-lock off, the camera will synchronize to the internal time base. Set the line-lock on,  
the camera’s vertical synchronization can be driven by the AC signal in the power lines.  
Note: The cameras feature AC line lock for external synchronization, using the AC power  
8
 
frequency (60Hz) is possible but not available in using DC or other operation power such as  
NTSC in 50Hz or PAL in 60Hz power system.  
VD/DD (Auto Iris lens Type)  
For video drive auto iris lens, please set switch to VD. For direct drive iris lens, set switch to DD.  
The default setting is DD. Wire the cable of lens to lens connector according to the following  
table.  
Pin1 Pin2  
Pin3  
Pin4  
Lens Connector  
Video Drive +12V  
Direct Drive Cnt-  
GND VD-IRIS GND  
6
1
2
3
4
Cnt+  
Drv+  
Drv-  
9
 
EverFocus Electronics Corp.  
Europe Office:  
Head Office:  
Albert-Einstein-Strasse 1  
D-46446 Emmerich, Germany  
TEL: 49-2822-9394-0  
12F, No.79 Sec. 1 Shin-Tai Wu Road,  
Hsi-Chih, Taipei, Taiwan  
TEL: +886-2-26982334  
FAX: +886-2-26982380  
China Office:  
Room B-05D-1, KESHI PLAZA , Shangdi  
Information Industry Base,  
USA L.A. Office:  
1801 Highland Ave. Unit A  
Duarte, CA 91010, U.S.A.  
TEL: +1-626-844-8888  
FAX: +1-626-844-8838  
Haidian District, Beijing China  
100085  
TEL: +86-10-62973336/37/38/39  
FAX: +86-10-62971423  
USA N.Y. Office:  
Japan Office:  
415 Oser Avenue Unit S  
Hauppauge, NY 11788  
TEL: 631-436-5070  
FAX: 631-436-5027  
1809 WBG MARIBU East 18F,  
2-6 Nakase.Mihama-ku.  
Chiba city 261-7118, Japan  
TEL: +81-43-212-8188  
FAX: +81-43-297-0081  
Your EverFocus product is designed and  
manufactured with high quality materials and  
components which can be recycled and  
reused.  
Ihr EverFocus Produkt wurde entwickelt und  
hergestellt mit qualitativ hochwertigen  
Materialien und Komponenten, die recycelt  
und wieder verwendet werden können.  
Dieses Symbol bedeutet, dass elektrische und  
elektronische Geräte am Ende ihrer  
Nutzungsdauer vom Hausmüll getrennt  
entsorgt werden sollen.  
This symbol means that electrical and  
electronic equipment, at their end-of-life,  
should be disposed of separately from your  
household waste.  
Please, dispose of this equipment at your  
local community waste collection/recycling  
centre.  
Bitte entsorgen Sie dieses Gerät bei Ihrer  
örtlichen kommunalen Sammelstelle oder im  
Recycling Centre.  
Helfen Sie uns bitte, die Umwelt zu erhalten, in  
der wir leben!  
In the European Union there are separate  
collection systems for used electrical and  
electronic product.  
Please, help us to conserve the environment  
we live in!  
P/N: MED3G03000_Ver.B  
10  
 

Cooper Lighting Indoor Furnishings 201 IW User Manual
Craftsman Lawn Mower LTS 1500 User Manual
Cuisinart Waffle Iron WMB 4A User Manual
Dacor Oven DYOV User Manual
Dimplex Electric Heater CASTILLO CST20 User Manual
Exido Coffeemaker 245 030 User Manual
Extron electronic Stereo Receiver DVI DL 201 Rx User Manual
Fisher Price Motorized Toy Car W2602 User Manual
Fundex Games Games Double Nine Dominoes User Manual
GE Dust Collector MM300 User Manual