DG-1000M
Stand alone Access Controller
70
35.5
1
2
3
4
127.5
5
8
0
6
9
#
7
*
Unit: mm
Convenient record listing of the user
card and password thru the connection
to the PC with USB.
Features
Allows up to 1000 proximity cards and PIN codes
Tamper switch and alarm buzzer included
Fully Programmable via keypad and master code
Access mode selectable:
card only ；card or PIN ；card+PIN
Logical memory to prevent duplication
Invalid PIN Lock-out
Beeper sound gives of keypad composition
Non-Volatile Memory
Removable memory chip replacement
Mifare High Frequency 13.56MHz
Stand-Alone Proximity Reader with USB Connector
Software Free of Charge
Overview
The DG-1000M offers one version request command and two
memory exchange commands. These memory commands,
used with knowledge of the EEPROM layout, allow almost
complete control over configuration, holder and transaction
memory. The exception to memory access is the
automatically-maintained memory contained within address
0x7000 and0x8000. This area contains checksums,
configuration backups and integrity markers to ensure the
validity of data on the unit.
GIANNI INDUSTRIES, INC.
No.306-1, Hsin Shu Road, Hsin Chuang, Taipei,Taiwan 242
TEL: 886-2-2206 9929
E-Mail: [email protected]
Website: gianni.tw
The products are manufactured under an ISO
9001 QC 080000 Certified Quality
Management Program environment back its
product quality, performance and commitment
to customer satisfaction.
FAX: 886-2-2204 6632
&
GP001
Copyright © 2008 Gianni industries, inc. All rights reserved.
DM-CA-DG-1000M Ver. C Published on 2008.05.05
|